Instruction manual

15
B O S C H
You can download this manual from the local homepages of Bosch.
Problem Possible causes Solution
The soleplate turns
brown.
• This is a regular
consequence of continued
use over a long period of
time.
• Clean the soleplate with a
damp cloth.
The appliance
makes a pumping
sound.
• Water is being pumped
into the steam tank.
• The water tank is not tted
onto the housing correctly.
• The sound will not stop.
• This is normal.
• Fit the water tank back onto
the hou sing correctly (you will
hear a click).
• If the sound will not stop, do
not use the steam generator
and contact an authorised
technical service centre.
Loss of pressure
during ironing.
• Steam release button has
been activated for too long
a period of time, that is,
it has been pressed too
frequently.
• Use the steam release button
at intervals. This improves
the ironing result as the
textiles will be steamed, dried
and ironed properly.
Water spots appear
on the garment
during ironing.
• May be caused by steam
condensed on the ironing
board.
• Wipe the textile cover of the
ironing board, and iron any
water drops to dry them.
Water spots appear
on the garment
during use of the
“PulseSteam”
function.
• Water spots are caused by
steam condensation in the
hose when cooling down
after use.
• Water drops stop coming out
of the soleplate after using
the “PulseSteam” function for
some time.
The hose gets hot
during use.
• This is normal. It is caused
by the steam passing
through the hose during
steam ironing.
• Place the hose on the
opposite side so that you
cannot touch the hose during
ironing.
Water leakage from
the boiler.
• Drainage plug located
at the bottom of the
appliance is loose.
• Tighten up the boiler drainage
plug with a coin
The iron does not
stop steaming after
placing it on the pad
(2).
• “PulseSteam” function has
been activated by double
click.
• Just press the trigger once
again and the iron will stop
steaming at once.
If the above does not solve the problem, get in touch with our customer service.