Instruction manual

9
B O S C H
When the steam release button is
activated, the steam generator will
release three powerful shots of steam
so that the steam reaches even deeper
into the fabrics.
1. Set the temperature selector (11) on
“•••”
2. Briey press the steam shot button
(13*) on the top of the handle.
or (model dependent)
Press the steam release button (12)
on the bottom of the handle two times
in quick succession (double-click).
Remarks:
• It is possible to stop the shots of
steam by quickly pressing the steam
button again.
• Some water drops may appear when
you use the “PulseSteam” function
for the rst time.
The water drops will disappear after
you have used the function for some
time.
6
Ironing without
steam
Begin ironing but without pressing the
steam release button.
7
Vertical steam
This can be used to remove creases
from hanging clothes, curtains etc.
Warning!:
• Never direct the steam jet at
garments that are being worn.
• Never aim the steam at people or
animals.
1. Set the temperature to the “•••” setting.
2. Hold the iron in an upright position
15 cm away from the garment being
steamed.
3. You can steam iron curtains and
hanging garments (jackets, suits,
coats...) by placing the iron in a
vertical position and pressing the
steam release button (12-13*).

8
“Intelligent steam”
function
(model dependent)
This system has intelligent steam
control, which, after releasing the steam
release button (12-13*), provides a
small amount of additional steam.
The additional steam can always be
stopped by briey pressing the steam
release button once again.
9
Energy saving
“eco” setting
(model dependent)
If the “eco” steam setting on the steam
control (5*) is selected, the energy
consumption of the appliance will be
reduced, by means of the reduction of
water consumption and electricity.
A good ironing result can be obtained
for most garments.
Use higher settings only for thick and
highly wrinkled fabrics.
10
Auto shut-off
(model dependent)
If during ironing, the steam release
button (12-13*) on the iron handle
is not pressed for a certain length of
time (8 minutes), the steam station will
automatically switch off.
The “auto shut-off” pilot lamp (4) will
ash when auto shut-off has been
activated.
To switch the steam station back on,
press the steam release button again.