Operation Manual

26 en | Navigating the Monitor Bosch HD LCD Monitors
F.01U.272.027 | 1.0 | 2012.08 User's Manual Bosch Security Systems, Inc.
6.2 Using the Monitor On-screen Display
(OSD)
The LCD is programmed through the on-screen display (OSD)
menus and submenus where an operator can select operating
parameters. To access the OSD menus, press the Menu button
on the control panel. Use these controls to make any necessary
adjustments to the OSD.
To navigate the set up menus, follow the steps below:
1. Connect a video source cable to the monitor.
2. Press the Power button to turn on the unit.
3. If required, press the SOURCE or ENTER button and then
the and the and buttons until a signal is displayed.
4. Press the Menu button to activate the main menu
selections.
5. Press the and buttons to select a menu.
6. Press the button to enter the selected menu.
7. Press the and buttons to select a sub-menu item.
8. Press the and buttons to toggle the OSD values.
9. Press the Menu button to exit the selected menu and to
return to the menu bar or to confirm a selection.
10. Press the Menu button again to exit the OSD menu bar.
NOTICE!
When you are navigating through the OSD menus, use the
SOURCE or ENTER button to select a menu and use the MENU
button to exit a menu.