Installation manual

10 en | Assembly and Installation Washer Kit
F.01U.206.249 | 2.0 | 2010.12 Installation Manual Bosch Security Systems, Inc.
4.3 Installing the Washer to the UPH
1. After attaching the support (item 1, bracket or column support), position the washer
pipe support (item 3) in the desired position. Insert the cables inside the support so that
they protrude by about 50 cm (19.68 in.).
2. Insert the cable in the cable glands (item 2) and, keeping the base (item 4) at about
20 cm (7.87 in.) from the support, lock the cable glands.
3. Set the base on the support, aiding the cables to achieve the correct position inside.
Attach the base to the support using the new screws supplied (item 5).
4. Cut the cables to size and either restore or make the connections to the positioning unit.
When you have attached the base to the support, shorten the washer pipe (item 1,
below) as required and attach it to the coupling as follows: undo the nut (item 2) from
the coupling, insert it into the pipe and insert the end of the pipe on the nosecap (item
3).
5. Lock the nut to the coupling.
NOTICE!
To attach the base to the support use the new screws provided (item 5, below) and make sure
the washers (item 6) are present, as well as the screw seals (item 7) and the gasket (item 8).