Installation manual

Washer Kit Description | en 5
Bosch Security Systems, Inc. Installation Manual F.01U.206.249 | 2.0 | 2010.12
2 Description
A washer kit for the UPH Series High-speed Positioning System. Available in 230 VAC (HAC-
WAS05-50 and HAC-WAS30-50) or 24 VAC (HAC-WAS05-20). The standard pump guarantees a
delivery up to a maximum of 5 m (16.4 ft), while the high delivery version (HAC-WAS30-50)
delivers up to 30 m (98 ft). It is possible to adjust the articulated nozzle of the pump
associating it to a preset in order to obtain the desired position of the wiper and sprinkle
functions. The pumps, equipped with relay, allow the direct connection to the UPH. Further,
in the high delivery version, the lack of liquid in the reservoir is signalled to the operator with
the stop of the pump itself.
3 Preparing the Product for Use
3.1 Contents and Unpacking
When the product is delivered, make sure that the package is intact and that there are no
signs that it has been dropped or scratched. If there are obvious signs of damage, contact the
supplier immediately. Keep the packaging in case you need to send the product for repairs.
Check the contents to make sure they correspond with the list of materials as below:
– Washer kit for UPH Series High-speed Positioning System
– Washer pipe support
– Locking bracket for pipe support
– Screws and washers
– Washer pipe with nozzle
–Pipe connector
–Clamp
– Housing equipment
– Installation manual
3.2 Safely Disposing of Packaging Material
The packaging material can all be recycled. The installer technician will be responsible for
separating the material for disposal, and in any case for compliance with the legislation in
force where the device is to be used.
Bear in mind that if the material has to be returned due to a fault, using the original packaging
for its transport is strongly recommended.
CAUTION!
Any change that is not expressly approved by the manufacturer will invalidate the guarantee.