Installation manual

6 en | Assembly and Installation Washer Kit
F.01U.206.249 | 2.0 | 2010.12 Installation Manual Bosch Security Systems, Inc.
4 Assembly and Installation
4.1 Installing the Pump Tank
1. Attach the metal cage (item 1, below) firmly to a wall using the four (4) holes provided
for this (item 2).
2. Remove the cap from the tank with the corresponding pump or level controller. Remove
the tank from the metal cage.
DANGER!
In the 115/230 VAC powered configuration it is necessary to insert a 1 0 unipolar main switch
(open contact distance d>3 mm) upstream on the power line. This switch should be used to
disconnect the power supply before carrying out any maintenance operation or before
opening the housing.
CAUTION!
Only qualified personnel should assemble and install the device.
CAUTION!
If using the pump at temperatures below 3°C (37.4°F) add some motor vehicle-type antifreeze
to the water.
HAC-WAS05-20
HAC-WAS05-50 HAC-WAS30-50