Technical data

Fig.7-18: Dialog for creating and internally storing network settings
If this dialog is acknowledged by "Yes" and the subsequent saving of the inter‐
nal file was successful, you will receive the following notice:
Fig.7-19: Confirmation that network settings have been saved
The notice in figure 7-19 is confirmed by means of the "Apply data "key.
The device will subsequently restart with the settings determined in "Rexroth
settings". Check "Rexroth settings" after successful registration of the internal
file.
If on switching on the IndraControl VCH 08.1 an IndraControl VAC 30.2 with
memory function is recognized and the data for network configuration are suc‐
cessfully read, this configuration always has priority.
If, however, no configuration data are found in the VAC 30.2, the IndraControl
VCH 08.1 starts with the internally saved settings.
In both cases this is communicated by the output sequence as illustrated in
figures 7-17, 7-18 and 7-19.
Project Planning Manual | Rexroth IndraControl VCH 08.1 Electric Drives
and Controls
| Bosch Rexroth AG 53/80
Pin Assignments of the IndraControl VCH 08.1
Priority of the Network Settings
from
the Connection Module Indra‐
Control VAC 30.2