Technical data

9 Software
9.1 Overview
Thehand-held terminal
IndraControl VCH 08.1 is supplied with a pre-installed
software which is permanently stored in the Flash of the device. This software
is also referred to as "Image" as it combines all software content in a single file.
The Image contains the Windows CE operating system kernel and possibly
additional applications.
This description applies to Images from Version 1.00 and higher (indication of
the version via configuration tool, see chapter 9.5.3 " Configuration Tool (Config
Tool)" on page 66).
The IndraControl VCH 08.1 IndraControl VCH 08.1 is equipped with the fol‐
lowing software as standard:
● Windows CE 5.0 .NET operating system:
● Flash file system:
– FlashDrv
● Pre-installed application programs:
– VI-Composer Runtime
– Standard appliacations
– Configuration tool (extension in system control for the configuration
of contrast, brightness, backlight, screen saver, joystick and poten‐
tiometer calibration, deleting of registry, image update, ...)
– "Rexroth settings"
9.2 Starting the IndraControl VCH 08.1
9.2.1 General Information
The following setting dialogs of the IndraControl VCH 08.1 are available:
● In "Start-up application" you select whether to start the customer applica‐
tion or change the system settings, for further information about this see
chapter 9.2 "Starting the IndraControl VCH 08.1" on page 57.
● In "Service application" the access password for the "Service dialog" is
requested, for further information about this see chapter 9.2.4 "Service
Dialog" on page 60.
● In "Service dialog" you can assign a new password and you can access
the setting dialogs "Rexroth settings" and "Config tool", for this see chapter
9.2.4 "Service Dialog" on page 60.
● In "Rexroth settings" you can enter the network parameters, for this see
chapter 9.2.6 "Rexroth Settings" on page 61.
● In "Config tool" you can set some of the sotware and hardware parame‐
ters, for this see chapter 9.2.5 "Config Tool" on page 61.
The following overview (fig. 9-1 "Structure of the setting dialogs" on page
58) highlights the structure of the setting dialogs:
Project Planning Manual | Rexroth IndraControl VCH 08.1 Electric Drives
and Controls
| Bosch Rexroth AG 57/80
Software