Technical data

9.5 Operating Notes for the VCH 08.1
9.5.1 General Information
This
chapter describes deviations from conventional Windows CE devices and
Rexroth-specific settings.
9.5.2 Setting of Date and Time
The setting options for date and time are not yet supported by the system.
9.5.3 Configuration Tool (Config Tool)
General Information
The Config tool serves for the calibrating, the simple function checking of the
operating elements and for setting the start-up functions.
The Config tool can be called in the start-up mask as follows:
Service ▶ Configuration tool
The appearance of the Config tool depends on the operating ele‐
ments installed in the IndraControl VCH 08.1
(the menus for OV
potentiometer, joystick and hand wheel are only displayed if these
operating elements are integrated in the device).
If you have executed any changes to the configuration and you exit the program,
you
are given the option to permanently saving all the changes in the registry
via "Registry Backup".
For specific modifications (e.g calibration) a window containing the following
message and selection option appears on exiting the program:
"Data has changed! Do you want to write the registry to the flash? Yes/No"
When you chose "No" the settings are not saved and will be lost on switching
off the IndraControl VCH 08.1.
When chosing "Yes" the settings are permanently saved to the flash and are
maintained when switching the device back on again. During the saving proc‐
ess the device is blocked for a maximum of 10 seconds.
Potentiometer Calibration
You will find the "potentiometer" register in the "Config tool", see chapter 9.5.3
" Configuration Tool (Config Tool)" on page 66.
Fig.9-10: Dialog for potentiometer calibration
66/80 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth IndraControl VCH 08.1 | Project Planning Manual
Software