Technical data

The potentiometer calibration is started via the "Calibrate"
button, see fig. 9-10
"Dialog for potentiometer calibration" on page 66. The slider moves analogously
to the potentiometer setting. For verification purposes the current value is also
displayed as a numeric value. After the calibration has been completed this
number indicates the current value of the potentiometer (value range: 0 to 127).
Display Settings
You will find the "display/touch" register in the "Config tool", see chapter 9.5.3
" Configuration Tool (Config Tool)" on page 66.
Fig.9-11: Dialog for display settings
In this dialog you can set the brightness and contrast.
Setting the Zero Point of the Handwheel
You will find the "hand wheel" register in the "Config tool", see chapter 9.5.3 "
Configuration Tool (Config Tool)" on page 66.
Fig.9-12: Dialog for handwheel settings
The hand wheel provides a 16 bit value that can be freely processed in customer
application (e.g.: 0-65535, +/-32767, ...).
The value ranging from 0 to 65535 is displayed in the dialog box. The value of
the hand wheel is set to 0 when switching on the device. On actuation of the
"Reset" key the value of the hand wheel is reset to 0.
Project Planning Manual | Rexroth IndraControl VCH 08.1 Electric Drives
and Controls
| Bosch Rexroth AG 67/80
Software