Technical data

Fig.1-2: Front view of the VAC 30.2
1.6 Operating System
For license related reasons IndraControl VCH 08.1 -type devices are only sup‐
plied with previously installed operating systems. For further information about
the operating system, please refer to chapter 9 "Software" on page 57.
1.7 Start up
Mount the IndraControl VAC 30.2 connection module according to the instruc‐
tions in chapter 5 "Dimensions" on page 23. Next, connect the connection
module to the power supply, the STOP circuit, the enabling circuit and to the
network.
Before starting up the IndraControl VCH 08.1 the operator must ensure that the
system, and especially the safety equipment, is in correct working order.
Before starting up the IndraControl VCH 08.1 it must be ensured
that the STOP push button is not depressed. The connection of a
IndraControl
VCH 08.1 with a depressed STOP push button would
shut down the system.
To connect the IndraControl VCH 08.1, without applying any force, fit the angled
connector
onto the flange of the VAC 30.2 connection module at an angle of
45° (to horizontal); refer tofig. 1-3 "Plug orientation at the
IndraControl VAC 30.2" on page 4. The correct position is only achieved if
the connector snaps in to place properly. Now turn the knurled nut on the flange,
applying a little pressure.
Project Planning Manual | Rexroth IndraControl VCH 08.1 Electric Drives
and Controls
| Bosch Rexroth AG 3/80
System Presentation