Technical data

3 Safety Instructions for Electric Drives and Controls
3.1 Introduction
Read at first the following notes before startup procedure to avoid personal
injury and/or material damages! This safety notes are always to be observed.
Do not try to install this machine or take into commission before you haven`t
read all delivered documentations exactly. This safety instructions and all other
user notes must always been read before working with this machine. Should
you have no user notes for this machine, please contact your responsible sales
representative at Rexroth Indramat. Ask for prompt sending of this documen-
tations to the responsible person to use this machine safely.
You have to pass this safety notes when you sell, lend out or otherwise pass
this machine.
WARNING
Improper use of this equipment, failure to follow the attached safety in-
structions, or tampering with the product, including disabling or discon-
nection the safety device, may result in injury, severe electrical shock
or death and material damage!
Observe the following instructions.
3.2 Explanation
The safety instructions describe the following degrees of hazard seriousness.
The degree of hazard seriousness informs about the consequences resulting
from non-compliance with the safety instructions:
Warning symbols with signal word Hazard classification (according to ANSI Z 535)
DANGER
Death or severe bodily injury will occur.
WARNING
Death or severe bodily injury may occur.
CAUTION
Bodily injury or damage may occur.
Fig.3-1: Danger classes (according to ANSI Z 535)
3.3 General
● Bosch Rexroth AG is not liable for damages resulting from failure to ob-
serve the warnings provided in this documentation.
● Read the operating, maintenance and safety instructions in your language
before commissioning the machine. If you find that you cannot completely
understand the documentation for your product, please ask your supplier
to clarify.
Project Planning Manual | Rexroth IndraDyn S Electric Drives
and Controls
| Bosch Rexroth AG 7/194
Safety Instructions for Electric Drives and Controls