Technical data

Fig.8-39: Installation methods
Dimension the connection cable depending on the type of applica-
tion according to DIN VDE 0298, Part 4, EN 60204-1.
8.6.2 Ready-Made Connection Cables
Rexroth provides ready-made power and encoder cables. The following docu-
mentation is available to help select cables.
You can find additional information ...
● in the documentation “Selection Data Connection Cables”; DOK-CON-
NEC-CABLE*STAND-AUxx-EN-P. All available power and encoder ca-
bles, as well as the combinations for IndraDyn S motors, are described
here.
Note: If installation modes that are not covered in classification "B2"
according to EN 60204-1 (1993) are required, larger cable cross-
sections may need to be used!
8.6.3 Cable Layout
A distance of at least 100 mm must be maintained between the power and the
encoder cables; otherwise, a metallic cable duct with separating bars must be
used.
Connection Cable
Project Planning Manual | Rexroth IndraDyn S Electric Drives
and Controls
| Bosch Rexroth AG 153/194
Connection Techniques