Technical data

Grind in the holding brake
Number of grinding-in revolutions 1
Ambient temperature -20°C to +50°C
Fig.12-1: Grinding the holding brake (rule)
The option of automatically implementing the grinding-in routine in
the program run is described in the documentation of the particular
drive controllers.
During normal operation, it is not necessary to grind in the brake. It is
sufficient if the brake is activated twice a day by removing the controller enable
signal.
12.5 Troubleshooting
In preparation
12.6 Dismantling
DANGER
Fatal injury due to errors in activating motors and working on moving
elements!
● Do not work on unsecured and operating machines.
● Secure the machine against accidental movements and against unau-
thorized operation.
● Before dismantling, secure the motor and power supply against falling or
movements before disconnecting the mechanical connections.
WARNING
Burning via hot surface with temperatures over 100 °C
● Do not work on hot surfaces.
● Use safety gloves.
⇒ Let the motor cool down, before maintenance. The stated thermical time
constant in the technical data is a measure for the cooling A cooling time up to
140 minutes can be necessary!
● Observe the instructions of the machine documentation.
● Please observe the safety notes.
● Dismantle the motor from the machine. Store the motor properly!
12.7 Waste Disposal
The manufacturing process of the products is executed in such a manner that
energy and raw materials are optimized; in addition the process permits recy-
cling and the utilization of incidental waste.
Bosch Rexroth regularly tries to replace polluted raw materials and supplies by
environmentally friendly alternatives.
Bosch Rexroth products do not contain any kind of dangerous substances
which could be released with proper use. Normally, no negative influences for
the environment can be assumed .
Manufacturing process
Application
186/194 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth IndraDyn S | Project Planning Manual
Commissioning, Operation and Maintenance