Technical data

CAUTION
Risk of injury by improper handling! Bodily injury by bruising, shearing,
cutting, hitting!
⇒ Observe the general construction and safety regulations on handling and
mounting.
Use suitable devices for mounting and transport.
⇒ Avoid jamming and bruising by appropriate measures.
⇒ Always use suitable tools. Use special tools if specified.
⇒ Use lifting equipment and tools in the correct manner.
⇒ If necessary, use suitable protective equipment (for example safety goggles,
safety shoes, safety gloves).
⇒ Do not stand under hanging loads.
⇒ Immediately clean up any spilled liquids because of the danger of skidding.
3.10 Battery Safety
Batteries consist of active chemicals enclosed in a solid housing. Therefore,
improper handling can cause injury or material damage.
CAUTION
Risk of injury by improper handling!
⇒ Do not attempt to reactivate low batteries by heating or other methods (risk
of explosion and cauterization).
⇒ Do not recharge the batteries as this may cause leakage or explosion.
⇒ Do not throw batteries into open flames.
⇒ Do not dismantle batteries.
⇒ Do not damage electrical parts which are mounted into the devices.
Environmental protection and disposal! The batteries contained in
the product are considered dangerous goods during land, air, and
sea transport (risk of explosion) in the sense of the legal regulations.
Dispose of used batteries separate from other waste. Observe the
local regulations in the country of assembly.
3.11 Protection Against Pressurized Systems
According to the information given in the Project Planning Manuals, some In-
draDyn motors, as well as drive controllers, can be partially supplied with
externally fed, pressurized media, such as compressed air, hydraulics oil, cool-
ing liquids and cooling lubricating agents. Improper handling of the external
supply systems, supply lines or connections can cause injuries or material
damage.
CAUTION
Risk of injury by improper handling of pressurized lines!
⇒ Do not attempt to disconnect, open or cut pressurized lines (risk of explosion).
⇒ Observe the respective manufacturer's operating instructions.
⇒ Before dismounting lines, relieve pressure and empty medium.
⇒ Use suitable protective equipment (for example safety goggles, safety shoes,
safety gloves).
⇒ Immediately clean up any spilled liquids from the floor.
Project Planning Manual | Rexroth IndraDyn S Electric Drives
and Controls
| Bosch Rexroth AG 13/194
Safety Instructions for Electric Drives and Controls