Use and Care Manual

WATER-LEVEL SENSOR MAINTENANCE
Clean the water level sensors occasionally:
1. Unlock the canister latches and remove the
control unit.
2. Clean the water level sensors with a soft
cloth.
3. Reattach the control unit again
4. Lock the canister latches.
-18-
Maintenance
Service
Preventive maintenance
must be performed by a
Bosch Factory Service Center or Autho -
rized Bosch Service Station. Service
performed by unauthorized per so n nel may
result in misplacing of internal wires and
components which could cause serious
injury.
TOOL LUBRICATION
Your Bosch tool has been properly lubricated
and is ready to use.
Cleaning
To avoid accidents
always dis connect the
tool from the power supply before
cleaning or performing any main tenance.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not at tempt to clean by inserting pointed
objects through openings.
Wipe dust off dust extractor control unit with
moist cloth. Use water to clean the canister
and attachments. Do not use dust extractor
until completely dry.
Certain cleaning agents
and sol vents damage
plastic parts. Some of these are: gasoline,
carbon tetrachlo ride, chlo rinated cleaning
solvents, ammonia and house hold
detergents that contain ammonia.
WATER-LEVEL SENSORS
FIG. 15
2610027608_VAC090 VAC140 6/26/17 1:12 PM Page 18