Datasheet

Switching and Control | Switching and Control Systems | 431
Allegiant Satellite Switching System
1 Monitor Outputs 14 Pan/Tilt/Zoom and Satellite
Control Data
2 Alarm Interface Unit 15 Monitor Outputs Used As Video
Trunk Lines to Main Control
Site
3 Pan/Tilt/Zoom and Satellite
Control Data
16 Video Trunk Lines From Other
Satellite Locations
4 Allegiant Main CPU Bay 17 Any Model Allegiant Main Bay
5 Inputs Used for Both Local
and Trunk Lines
18 Local Monitors
6 Local Camera Video Inputs 19 Satellite Data Line
7 Alarm Inputs May Activate Ei-
ther Local or Satellite Video
on Main Control Center's
Monitor
20 Console Port Input
8 Signal Distribution Unit 21 Data Converter Units
9 To Any Local PTZ Camera
Sites
22 To Any Local PTZ Camera Sites
10 Up to 1.5 km (5000 ft) Using
1 mm
2
(18 AWG) Shielded
Twisted Pair (Belden 8760 or
Equivalent)
23 Code Merger Unit
11 Allegiant Keyboard controls
any local or remote camera on
any local monitor (Video and
PTZ)
24 Alarm Interface Unit
12 Multiple Video Trunk Lines
From Each Remote Satellite
Location
25 Local PTZ Control Data Line
13 One Line to Each Remote Sat-
ellite System Location
26 Allegiant Keyboard controls
any local or remote camera on
any local monitor (Video and
PTZ)
27 Alarm Inputs Activate Only Lo-
cal Video on Local Monitors
Technical Specifications
LTC 8600 Series System Specifications
Capacities
Video Inputs Standard: 128
Satellite configuration: 1024
Video Outputs 16
•
Keyboards
16
•
Alarm Inputs
512
Receiver/Drivers Standard: 128
Satellite configuration: 1024
Electrical
Video Bandwidth (-3 dB) 12 MHz typical
Differential Gain 1% maximum
Differential Phase 2° maximum
K Factor 0.5%
Signal-to-Noise Ratio 70 dB minimum
Crosstalk
(Input to Input Isolation)
–50 dB typical
Feedthrough
(Input to Output Isolation)
45 dB typical
Gain Unity ± 2% (into 75 Ohm termination)
Tilt 1% typical
Transient Protection
(VIM Cards)
350 W Peak Pulse Power
(tp = 8/20 µs)
Environmental
Temperature
•
Operating
4°C to 50°C (40°F to 122°F)
•
Storage
–40°C to 60°C (–40°F to 140°F)
Altitude 4500 m (15,000 ft)
Humidity 0% to 95% relative, non-condensing
Vibration 3 g swept sine wave, 15 Hz to 2000 Hz
Shock 50 g, 11 ms, 1/2 sine wave
Product Regulatory Compliance
LTC 8601 Series Equipment Bay
Includes equipment rack, LTC 8610/01 microprocessor module, and
LTC 8805 Series power supply.
Power
Model No. Rated Voltage Voltage Range
Nominal Power
1
LTC 8601/60 120 VAC,
50/60 Hz
100 to 140 200 W
LTC 8601/50 220–240 VAC,
50/60 Hz
198 to 264 200 W
1. Power at rated voltage fully loaded.
Connectors
Video Inputs 1 to 96 One (1) sync input, and 16 monitor
outputs, BNC
www.boschsecurity.com Bosch Security Systems B.V.
8