Datasheet

510 | Digital Recording and Storage | Digital Video Recorders
Technical Specifications
Electrical
Rated Voltage and Power
Power input 100 to 240 VAC; 50/60 Hz
Power consumption Max. 2.5 to 1.0 A (250 Watt)
Video
Video standard PAL or NTSC auto-detection
Resolution 704x576 PAL, 704x480 NTSC
Compression H.264
Inputs 8 or 16 composite video 0.5 to 2 Vpp, 75 ohm
automatic termination
Outputs 8 or 16 composite video 1 Vpp, 75 ohm, sync
0.3 V ± 10%
Audio
Inputs 8 or 16 line in, mono RCA, 1 Vpp, 10 kohm
Output 2 line out, dual mono RCA, 1 Vpp, 10 kohm
Compression MPEG-2 layer II
Sampling rate 48 kHz per channel
Monitors
MON-A Live, playback, menus
VGA: analog RGB 1280x1024, 60/75 Hz (NTSC/
PAL)
CVBS: 1 Vpp, 75 ohm, BNC
Y/C
MON-B Live
VGA: analog RGB 1024x768, 60/75 Hz (NTSC/
PAL)
CVBS: 1 Vpp, 75 ohm, BNC
Y/C
Display Modes
Monitor A Full, full sequence, quad, multi-screen (live and
playback), event call-up (live)
Monitor B Full, full sequence, quad, multi-screen, event call-
up (live)
Frame rate PAL/NTSC 25/30 IPS per channel (real time)
Multiscreen mode 8
channels
1, 4, 9
Multiscreen mode 16
channels
1, 4, 9, 16
Zoom 1.5x, 2x, 3x, 5x
Alarm Handling
Inputs Screw terminal 8 or 16 inputs configurable NO/
NC,
Max. input 40 VDC
Outputs Screw terminal 4 relay outputs, configurable NO/
NC, max. rated 30 VAC, 40 VDC, 0.5 A, continu-
ous -10 VA
Remote notification Via Control Center software
Connections
Ethernet RJ45 modular jack 8 pins shielded:
10/100 Base-T
Biphase Screw terminal connector (5 outputs)
Maximum 5 controllable cameras per Biphase
output
Impedance 128 ohm, max. overvoltage protec-
tion ±40 V, max. cable length 1.5 km (0.9 miles)
Note: LTC 8785 translator needed for fixed-speed receivers/drivers
PTZ control interface RS485
Serial interface RS232 output signals according to EIA/
TIA-232 F, max. input voltage ±25 V
2xDB-9 male connector
Intuikey keyboard
(KBD Digital or
KBD Universal)
Conforms to RS485, max. signal voltage ±12 V,
power supply to keyboard 11 to 12.6 VDC at
max. 400 mA
RJ11 modular jack 6 pins
USB Five USB 2.0 ports
Network
Bandwidth control 0.1-100 Mbps limiter
Remote users Maximum 5 simultaneously connected Control
Center users
Protocol support TCP/IP, DHCP, DNS, and SNTP
IP cameras Up to 8 IP H.264 cameras (optional)
Supported IP H.264
devices
Dinion, FlexiDome, AutoDome Modular, EX series
IP cameras, VIP X series encoders (running firm-
ware 3.7 or later, max. 8 channels), and Auto-
Dome Easy
Storage
Internal HDD 250, 500, 750 GB, or 1 TB per disk
Up to 4 hard disks
Redundancy RAID-4 (4 hard disks)
(Optional, license required.)
Effective storage = Smallest disk x 3
Exporting
DVD Built-in DVD+R/RW recorder (optional)
USB Flash memory or external HDD (FAT32)
IP Control Center Software
Security
Password protection Multi-level
Image authentication All recordings and archives in native file format
Record Frame Rate
NTSC Up to 30 IPS per channel at 352x240, 704x240
and 704x480
PAL Up to 25 IPS per channel at 352x288, 704x288
and 704x576
IP Channels Up to 25/30 IPS per channel at 4CIF dependent
on connected IP device.
Recording
Overwrite modes Continuous, overwrite after 1 to 99 days
Pre-alarm recording Up to 120 s
Bosch Security Systems B.V. www.boschsecurity.com
9