Installation manual

OneTrack - © 2014 Video
Wave
37
4. The PTZ camera doesn’t track
Check if the type of tracking is selected in the <General> screen.
Check the serial converter connection.
Check the Rx and Tx connection.
Check that the selected protocol and camera model are correct.
Check the profile and schedule to see if everything in configured correctly.
5. The PTZ camera moves by small steps
Check in the Tour section if the “Use intermediate steps between presets” is checked.
6. The PTZ camera operate improperly
Check if the appropriate protocol is selected.
Check if the right communication mode has been selected (BIR, BIA, UNI).
In MultiTrack mode, check if your bridges works correctly.
7. Video signal shakes or have wavy lines
Check the BNC video cable.
Check your video amplifier (if one is installed).
Using a ground loop might be necessary.
8. No video signal in the OneTrack (black image)
Check that the camera is activated in the <General> screen.
Check that the video signal is not too weak.