Specifications
Table Of Contents
- General Purpose
- What’s New in This Release
- Continual Support
- American Dynamics
- ACTi Corporation
- Arecont Vision
- AXIS Communications
- Bosch
- CBC
- FLIR
- Panasonic Corp
- Samsung
- SONY
- Camera Specific Release Notes
- American Dynamics 8 Channel IP Encoder (M&H)
- American Dynamics Fixed IP Camera
- American Dynamics Fixed Camera (illustra 400 series)
- American Dynamics Fixed Camera (illustra 210, illustra 600 and illustra 610 Domes)
- American Dynamics Fixed Camera (illustra 600, 610 and 600LT Series Box and Bullets)
- American Dynamics IP SpeedDome
- ACTi Corporation
- Arecont Vision
- Axis Communications
- Bosch
- CBC
- FLIR
- Panasonic
- Samsung
- SONY
Samsung
28-2 Camera Handler Release Notes
Default Ports
• Port 80 for HTTP
• Port 554 for RTSP
Default Username & Password
Username: admin
Password: 4321
Limitations
• The following models have been tested and confirmed with Samsung SNV-5010, SNZ-5200,
SND-3080, SND-5080, SND-7080, SNP-3120, SNP-3371/3302(b), SNP-5200, SPE-400. All
other models listed have been confirmed with Samsung to work as designed under the
Samsung API but have not been tested by American Dynamics. There may be potential risks
when using these non-tested models.
• Interface 'CameraName' is not supported as the camera has no CGI command for this interface.
• Video standard change is not supported. The SND 3080, SNP 3120, SNB 3002 are fixed PAL /
NTSC. For other cameras there is a setting for changing PAL/NTSC on the Camera Web Gui but
this only changes the analog output.
• Samsung cameras have no CGI command for getting autofocus status, and only a few cameras
support setting it to on. The handler does not support autofocus property.
• Samsung cameras do not directly support video codec quality, but use compression rate on the
MJPEG stream for this purpose. A high level of compression equals a low level of quality. The
cameras' valid compression value range is 1-20. NVR reverse converts it to 5-100%. Quality is
not supported for H264 or MJPEG4 for any cameras.
SND-3080 does not support MJPEG stream compression. The camera’s web page has a quality
setting, but there is no specified API. So, the handler will not support MJPEG stream quality for
this camera.
• Most APIs of the camera run very slowly. Test results found setting a factory default can speed
up the response. Therefore, before adding a camera to the NVR, setting the camera to factory
default is recommended.
Test results:
•Changing resolution, FPS, quality will take about 30 seconds;
•Adding camera to NVR can take more than 15 s.
•Needs about 60s to display video when changing stream from stream 1
to stream 2; after clicking the apply button.
•Enabling dry contact might make the NVR consider the camera as
offline, thereby audio tab and dry contact tabs disappear. If this
happens, click Refresh
• Do not change the camera's video profile settings on the Camera Gui when the camera is added
to the NVR, otherwise changing FPS, resolution, bitrate or creating video stream may fail. Also
after the camera is added into NVR, the user MUST not change the current video standard
setting, or change the 2M/3M setting on the SND 7080.