Specifications

American Dynamics Fixed Camera (illustra 210, illustra 600 and illustra 610 Domes)
18-2 Camera Handler Release Notes
rtsp://camera_ip:7781/secondarystream (handler uses this).
• The rtsp A/V mixed stream URL is
rtsp://camera_ip:7778/primarystream
rtsp://camera_ip:7780/secondarystream.
• The end user can modify the port numbers via camera webpage.
• Handler will select one stream from camera, so the rtsp URL for MJPEG or H264 can be either
of these two URLs
Required Network Ports
• Port 80 is for HTTP
• Port 554 is for RTP/RTSP
Default Username & Password
• Username: admin
• Password: admin
Limitations
• When the primary and secondary streams are configured with the same codec, changing stream
on the NVR may change the opposite stream to the one you wish to change. The illustra 600
primary and secondary streams configuration will not necessarily reflect stream one and stream
two on the NVR. The camera only identifies the streams by the stream codec (ignoring FPS and
resolution). In some instances when NVR streams are both configured with the same Codec,
changing one of the streams will not necessarily change the parameters on the specified stream.
• illustra 600/610 camera only supports one 720P/1080P stream. If there is one 720P/1080P
stream on the NVR, it is impossible to set another. Please refer to the camera limitation.
• If the secondary stream is enabled via the Camera Web GUI, the camera will keep streaming
even when no user requires the stream. To meet the FPS set in the NVR, the other stream
should be set to a lower resolution, quality and FPS. Please refer to the camera FPS limitation
document.
• To meet the single stream fps, the user can enable dual stream on NVR, configure the stream
codec/resolution/fps/quality for Stream 1, and then configure Stream 2 to lowest
resolution/fps/quality. Once Stream 2 is configured the user can disable Stream 2 on the NVR.
Alternatively the user can access the camera’s web GUI settings to change stream 2 to the
lowest resolution/fps/quality.
• Changing codec and/or resolution will cause the network service to reboot; this takes about 25
seconds. It will continue to deliver previous video/audio streams in the first 15 seconds. During
this time, the camera will be offline. If the user refreshes the NVR web GUI, the properties will be
“unknown”, the camera may still be rebooting. If the video stream is not created successfully, the
properties will show “unknown”.
• For some properties, values that are retrieved from the camera itself (such as resolution or
quality), when a user adds the camera, the return value is not the default value but the value
defined by the camera.