Specifications
Table Of Contents
- General Purpose
- What’s New in This Release
- Continual Support
- American Dynamics
- ACTi Corporation
- Arecont Vision
- AXIS Communications
- Bosch
- CBC
- FLIR
- Panasonic Corp
- Samsung
- SONY
- Camera Specific Release Notes
- American Dynamics 8 Channel IP Encoder (M&H)
- American Dynamics Fixed IP Camera
- American Dynamics Fixed Camera (illustra 400 series)
- American Dynamics Fixed Camera (illustra 210, illustra 600 and illustra 610 Domes)
- American Dynamics Fixed Camera (illustra 600, 610 and 600LT Series Box and Bullets)
- American Dynamics IP SpeedDome
- ACTi Corporation
- Arecont Vision
- Axis Communications
- Bosch
- CBC
- FLIR
- Panasonic
- Samsung
- SONY
American Dynamics IP SpeedDome
20-3
• The maximum frame rate in dual streaming mode is:
• When codec is H.264/MJPEG:
•The maximum frame rate for the H.264 stream is 15fps @ D1
resolution @ quality 70, or 25fps @ 2CIF resolution @ quality 70, or
25fps @ D1 resolution @ quality 40; while the secondary MJPEG
stream is 7fps @ CIF resolution @ quality 70
• When codec is MPEG4/MJPEG:
•The maximum frame rate for the MPEG4 stream is up to 30fps at any
resolution and quality if the secondary MJPEG stream is set to 7fps @
CIF resolution @ quality 70. If the secondary MJPEG stream is set to
25fps @ D1 resolution @ quality 70, then the frame rate for the MPEG4
stream is up to 25fps @ D1 resolution @ quality 90.
• The zoom speed is fixed.
• Audio will not work unless it is enabled through the camera web interface.
• In victor, the Iris restore button does not work for ADIPDome Camera on victor Surveillance
view.
Known Issues
• When using IP Dome firmware 2.0.0.645 for streaming H264 only, users should not use rewind
instant play back with victor client. Users should use Search and Retrieve, or don’t configure
using a H264 stream.
• The default values for some properties defined on NVR are different from camera’s default.
• The dry contact state always returns unknown.
• The definition of preset and pattern in NVR might be changed by user via web-client.
• The NVR will not recognize any presets or patterns already on the dome when it is added to the
NVR.
• The NVR will not recognize any presets or patterns added to the dome via its web interface and
in fact the NVR may overwrite them.
• Preset and pattern definitions made on the NVR will be mirrored to the device, but not the other
way around.
• Preset and pattern definitions should be retained in case of network loss or disconnection /
reconnection.
• Preset and pattern definitions will not be deleted when the dome is deleted from the NVR.
• Clients should show only the presets and patterns that have been defined using the NVR (not all
96 slots, defined or not). Presets and patterns defined through the device web configuration will
not be shown
• When using the settings H.264 codec, D1 resolution, 25/30 (PAL/NTSC) FPS and the quality is
above 90, video will freeze when opening Live View.
• Iris restore button does not work for when using surveillance with victor.
Note
Please refer to the AD IP SpeedDome Release Notes for additional information.