Specifications
Table Of Contents
- General Purpose
- What’s New in This Release
- Continual Support
- American Dynamics
- ACTi Corporation
- Arecont Vision
- AXIS Communications
- Bosch
- CBC
- FLIR
- Panasonic Corp
- Samsung
- SONY
- Camera Specific Release Notes
- American Dynamics 8 Channel IP Encoder (M&H)
- American Dynamics Fixed IP Camera
- American Dynamics Fixed Camera (illustra 400 series)
- American Dynamics Fixed Camera (illustra 210, illustra 600 and illustra 610 Domes)
- American Dynamics Fixed Camera (illustra 600, 610 and 600LT Series Box and Bullets)
- American Dynamics IP SpeedDome
- ACTi Corporation
- Arecont Vision
- Axis Communications
- Bosch
- CBC
- FLIR
- Panasonic
- Samsung
- SONY
FLIR
26-5
3 Models: PT-Series/D-Series/F-Series
Steps for enabling the Second stream on the PT-Series/D-Series
Before setting a FLIR camera’s IP address on NVR, the user must enable
the second stream for each camera LEN on the PT-Series/D-Series/F-
Series.
Steps for enabling the second stream on each camera for PT-Series/D-
Series:
Open Camera Web Browser
On FLIR Systems Nexus Configuration Page:
Select “Modules”
Select “Video”
On VIDEO Configuration Page
Select Device ID #1 , Select Enabled=yes
Select “Save”
Select Device ID #3, Select Enabled=yes
Select “Save”
Stop Nexus Server
Start Nexus Server
Steps for enabling the second stream for F-Series:
Open Camera Web Browser
On FLIR Systems Nexus Configuration Page:
Select “Modules”
Select “Video”
On VIDEO Configuration Page
Select Device ID #1 , Select Enabled=yes
Select “Save”
Stop Nexus Server
Start Nexus Server
4 This steps are required only if incorrect camera model name is displayed
on NVR. Use the following steps to change the model:
Go to “
ip>/.serial”.
Change model name (i.e. F-324)
This field is shown as the “Name:” in the IRDeviceVersionGet CGI
response.