Specifications
Table Of Contents
- General Purpose
- What’s New in This Release
- Continual Support
- American Dynamics
- ACTi Corporation
- Arecont Vision
- AXIS Communications
- Bosch
- CBC
- FLIR
- Panasonic Corp
- Samsung
- SONY
- Camera Specific Release Notes
- American Dynamics 8 Channel IP Encoder (M&H)
- American Dynamics Fixed IP Camera
- American Dynamics Fixed Camera (illustra 400 series)
- American Dynamics Fixed Camera (illustra 210, illustra 600 and illustra 610 Domes)
- American Dynamics Fixed Camera (illustra 600, 610 and 600LT Series Box and Bullets)
- American Dynamics IP SpeedDome
- ACTi Corporation
- Arecont Vision
- Axis Communications
- Bosch
- CBC
- FLIR
- Panasonic
- Samsung
- SONY
Panasonic
27-7
Generic Does not support any other settings other than video, audio and event stream related
functions
The mode settings of H.264 and MPEG-4 operation need to be explicitly set at the camera.
On providing an incorrect password or configuring incorrect password group to Panasonic
camera there is some behavioral difference from other camera families where certain
properties are shown as “unknown” and certain GET only device properties are still
displayed (like mac-address, firmware version information, serial number etc…)
SP302, SP305, SP306 ,
(SF342, SF346)
Picture quality is 1.3 mega pixels; there are two aspect ratios 4:3 & 16:9. MPEG-4 is not
available when 16:9 is selected
When either H.264 or MPEG-4 transmission is set to On, the maximum frame rate for
MJPEG is 5fps
The maximum resolution for SP302/SF342 is 800x600. The maximum resolution for
Sp305/306 is 1280x960
(The maximum resolution for SP305/SP306/SF346 is 1280x960)
The mode settings of H.264 and MPEG-4 operation needs to be explicitly set at the camera
Video standard has been wrongly represented in this case as video mode, which is 1.3
megapixel mode, with 4:3 and 16:9 aspect ratio settings.
Image white-balance supports 3 settings, namely
“1” – Auto White balance control mode
“2” – Auto tracking white balance mode
“3” – Auto tracking white balance under a sodium lamp mode
When using MJPEG if a high quality setting is used while using the highest resolution of
1280x960, it results in streaming at a very high bit rate. This results in problem with Quick
time playing out the stream, as there is limitation of playback of streams with high bit rate by
QuickTime. However VLC seems to play it out quite fine. Solution is to use lower quality
settings, maybe within 75 for this resolution usage.
SP102, SP105 SP105 is a 1.3 mega pixel camera. The SP102 is a .32 megapixel camera. There are two
aspect ratios 4:3 & 16:9.
The maximum frame rate for MJPEG is 5fps.
The maximum resolution for SP102 is 640x480. The maximum resolution for SP105 is
1280x960
The mode settings of H.264 operation needs to be explicitly set at the camera
Video standard has been wrongly represented in this case as video mode, which is 1.3
megapixel mode ( for SP105 ) or vga mode (for SP102) , with 4:3 and 16:9 aspect ratio
settings.
Image white-balance supports 3 settings, namely
“1” – Auto White balance control mode
“2” – Auto tracking white balance mode
“3” – Auto tracking white balance under a sodium lamp mode