Specifications

Bosch Security Systems | 2006-03 | V2.0 Appendix
VIP X1600 | Installation and Operating Manual EN | 119
Communication with terminal program
Data terminal
In the case where a VIP X1600 module cannot be found in the network or the
connection to the network is interrupted, you can connect a data terminal to the
VIP X1600 module for implementation and setting of important parameters.
The data terminal consists of a computer with a terminal program.
You require a serial transmission cable with a 9-pin Sub-D connector to connect
to the computer and open ends for connection to the terminal plug of the
VIP X1600 module (pin assignment see page 118).
HyperTerminal, a communications accessory included with Microsoft Windows,
can be used as the terminal program.
Note
Information on installing and using HyperTerminal can be found in the
manuals or in the online help for MS Windows.
– Disconnect the VIP X1600 from the Ethernet network before working with the
terminal program.
– Connect the serial interface of the VIP X1600 module using any available
serial interface on the computer.
Configuring the terminal
Before the terminal program can communicate with the VIP X1600 module, the
transmission parameters must be matched. Make the following settings for the
terminal program:
❚ 19,200 bit/s
❚ 8 data bits
❚ No parity check
❚ 1 stop bit
❚ No protocol