Specifications

Bosch Security Systems | 2006-03 | V2.0 Appendix
VIP X1600 | Installation and Operating Manual EN | 121
– Enter 1 again. The terminal program displays the current IP address and
prompts you to enter a new IP address.
– Enter the desired IP address and press Enter. The terminal program displays
the new IP address.
– Use the displayed commands for any additional settings which you require.
Note
You must restart to activate the new IP address, a new subnet mask or a
gateway address.
Restart
Briefly interrupt the power supply to the VIP X1600 for a restart (disconnect the
power supply unit from the mains supply and switch on again after a few sec-
onds).
Additional parameters
You can use the terminal program to check other basic parameters and modify
them where necessary. Use the on-screen commands in the various submenus
to do this.