Specifications

Installation Bosch Security Systems | 2006-03 | V2.0
EN | 22 Installation and Operating Manual | VIP X1600
Connections
Cameras
A maximum of four standard video sources (for example CCTV cameras) can be
attached to each VIP X1600 module. Any cameras and other video sources that
produce a standard PAL or NTSC signal are suitable.
– Attach the cameras or other video sources using a video cable (75 Ohm,
BNC plug) to the BNC jacks Video In 1 to Video In 4 for each mounted
VIP X1600 module.
– If the video signal is not looped through, termination is performed by software
setting if required (see Video input, page 46).
Data interface
The bidirectional data interface of each VIP X1600 module is used to control the
connected units, for example a dome camera with motorized lens. The range of
controllable equipment is expanding constantly. The manufacturers of the rele-
vant equipment can provide specific information on installation and control.
The serial interface supports the RS232, RS422 and RS485 transmission stan-
dards. Connection is via the terminal connector. See page 118 for the pin
assignment.
Caution
Please take note of the appropriate documentation when installing and op-
erating the unit to be controlled. The documentation contains important
safety instructions and information about permitted uses.
Note
A video connection is necessary to transmit transparent data.