User manual

Bosch Security Systems User Manual 2012.11
960H Day/Night IR Bullet Camera Installation | en 9
6 Installation
6.2 Monitor connection
6.3 Camera adjustment
CAUTION!
To prevent humidity problems, the camera must be installed in
dry conditions. The lens knobs (located on the bottom of the camera)
and protection cap (located on the rear of the camera) provide protection
against water ingress when fully tightened. Therefore never remove or keep
them loosened after installation. Doing so could cause water ingress and/or
condensation on the inside of the camera window.
1.
2.
3.
4.
5.
6.
7.
8.
Open the protection cap on the rear of the camera
(only needed to access service monitor connection and OSD control)
Connect service monitor (optional)
Loosen the zoom and focus knob
Adjust zoom and focus
Fasten the zoom and focus knob tightly
Adjust OSD settings (refer to OSD section)
Disconnect service monitor cable (optional)
Check rubber seal is in place on the protection cap. Close and rmly tighten
the protection cap on the rear of the camera.
DUAL(DC12V/AC24V) Regulated Power Supply
DUAL (DC12V/AC24V)
*Sold separately
Video In
TV Monitor
Camera
Female
BNC connector
Ground contact
Signal contact
Terminal block
Terminal block connector
Screw
Terminal
"+","-" Indication

2.6x3.2
(0.1x0.12)
10.16
(0.4)
5.08(0.2)
15.4(0.6)
18.2(0.71)
mm
(in.)