Data Sheet

ManualsBrandsBosch ManualsElectronicsTwo- Wire Ceiling-Mount Multi-Candela Strobes

Fire Alarm Systems | W‑STxC Ceiling‑mount Multi‑candela Strobes

W‑STxC Ceiling‑mount Multi‑candela

Strobes

www.boschsecurity.com

u Sleek modern aesthetics

u Multiple voltages (12 VDC or 24 VDC)

u Voltage test points

u Eight strobe candela options

u Universal mounting base

The Cooper Wheelock Exceder Series Strobes feature

a sleek modern design that incorporates high reliability

and high-efficiency optics to minimize current draw.

The reduced current draw allows for a greater number

of devices on the two‑wire notification appliance

circuit. This, in combination with eight candela options

in one appliance, no tools needed for changing

settings, voltage test points, 12 V or 24 V DC

operation, the universal mounting base, and multiple

mounting options results in a reduced cost of

ownership.

These strobes provide eight candela settings. All the

switches to change these settings can be set without a

tool and are located behind the appliance to prevent

tampering.

The separate universal mounting base can be easily

mounted to five industry‑standard back box types.

They can also be pre‑wired to allow full testing of the

circuit wiring before the appliance is installed and the

surface finished. These wall‑mounting strobes also

feature voltage test points for taking readings with a

volt meter for troubleshooting or AHJ inspection.

Certifications and approvals

Cooper Wheelock holds these Listings and Approvals:

Region Certification

USA UL UUKC: Signaling Appliances and Equip-

ment for the Hearing Impaired (ANSI/UL

1971), UVAV: Visual-signal Appliances

for Fire-protective Signaling Systems

(ANSI/UL 1638)

CSFM see our website

Installation/configuration notes

Compatibility

Strobe:

These strobes provide a non-synchronized strobe

appliance when connected directly to a Fire Alarm

Control Panel (FACP), or provide a synchronized

strobe appliance when used in conjunction with an

FACP that incorporates the Cooper Notification sync

protocol, a Cooper Notification Sync Module, or the

Cooper Notification Power Supply. They are designed

to flash at 1 flash per second minimum over their

Regulated Voltage Range.

Summary of content (3 pages)

PAGE 1
Fire Alarm Systems | W‑STxC Ceiling‑mount Multi‑candela Strobes W‑STxC Ceiling‑mount Multi‑candela Strobes www.boschsecurity.com The Cooper Wheelock Exceder Series Strobes feature a sleek modern design that incorporates high reliability and high-efficiency optics to minimize current draw. The reduced current draw allows for a greater number of devices on the two‑wire notification appliance circuit.
PAGE 2
| W‑STxC Ceiling‑mount Multi‑candela Strobes Parts included Notice Strobes are not designed to be used on coded systems in which the applied voltage is cycled on and off. Compatible Products The following Bosch Security Systems, Inc. products are compatible with the Cooper Wheelock Exceder Series Strobes: Quant.
PAGE 3
| W‑STxC Ceiling‑mount Multi‑candela Strobes Trademarks All hardware and software product names used in this document are likely to be registered trademarks and must be treated accordingly. Ordering information W‑STRC Ceiling-mount Multi‑candela Strobe (two‑wire, 12/24 V, red) Circular red two‑wire strobe that is field‑selectable for eight candela options.