Installation and Operation Guide

Faults and what to do about them en
31
Information on the display panel
Display Cause/remedial action
YES The washing machine door is unlocked. It is possible to add laundry.
NO ■ The temperature is too high. Wait until the temperature falls.
■ Water level too high. Not possible to add laundry. If necessary, close the wash-
ing machine door immediately. To continue the programme, press Start/
Reload A .
¼ flashes ■ Laundry may be caught. Please open and close the washing machine door
again and press Start/Reload A .
■ If necessary, push the washing machine door closed or remove the laundry and
push it closed again.
■ If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
E:17 ■ Turn the water tap on fully,
■ The supply hose is kinked/trapped,
■ The water pressure is too low.
– Clean the filter in the water supply. ~ Page 29
– If an additional water filter has been installed (depending on model)
~ Page 11, check for contaminants and clean if required ~ separate
installation and cleaning instruction for water filter.
E:18 ■ The detergent solution pump is blocked. Clean the detergent solution pump.
~ Page 28
■ The drain hose/waste pipe is blocked. Clean the drain hose at the siphon.
~ Page 29
E:23 Water in the base tub, appliance leaking. Turn off the water tap. Call the after-sales
service. ~ Page 34
D The childproof lock is activated; to deactivate:
N flashes Too much foam detected, a rinse cycle has been switched on.
: The mains voltage is too low. ~ Page 26
. Undervoltage in the wash programme. The programme is extended. ~ Page 34
Other displays Switch off the appliance, wait for 5 seconds and switch it back on again. If the dis-
play appears again, call the after-sales service. ~ Page 34