Installation Instruction
Table Of Contents
- en Instruction Manual and Installation Instructions
- Display rules
- : Warning!
- Caution!
- Note/tip
- 1. 2. 3. / a) b) c)
- Contentsen Instruction Manual and Installation Instructions
- 8 Intended use 4
- ( Safety instructions 5
- 7 Environmental protection 9
- 5 Positioning and connecting 10
- * Getting to know the appliance 16
- Z Laundry 19
- C Detergent 20
- 0 Programme default settings 21
- \ Additional programme settings 23
- 1 Operating the appliance 23
- Q Appliance settings 28
- 2 Cleaning and maintenance 29
- 3 Faults and what to do about them 32
- 4 After-sales service 35
- 8 Intended use
- ( Safety instructions
- Safety instructions
- Children/people/pets
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- Useful tools
- : Warning
- : Warning
- : Warning
- : Warning
- * Getting to know the appliance
- Getting to know the appliance
- Washing machine
- Control panel
- Display panel
- More information on the display panel
- Display indicator
- Description
- Note:
- Z Laundry
- Laundry
- Preparing the laundry
- Sorting laundry
- Soaking
- 1. Pour soaking agent/detergent into compartment II in accordance with the manufacturer's instructions.
- 2. Select the desired programme.
- 3. Press the A button to start the programme.
- 4. After approx. ten minutes, press the A button to pause the programme.
- 5. After the desired soaking time, press the A button again to continue or change the programme.
- Notes
- C Detergent
- 0 Programme default settings
- \ Additional programme settings
- 1 Operating the appliance
- : Warning
- : Warning
- Eye/skin irritation!
- Starting the programme
- Childproof lock
- Adding/removing laundry
- Changing the programme
- Cancelling the programme
- Programme end during Rinse Stop
- Programme end
- Removing laundry/switching off the appliance
- Q Appliance settings
- Activating the setting mode
- Changing the volume
- : Warning
- : Warning
- Risk of poisoning!
- Damage to the appliance
- Machine housing/control panel
- Drum
- Descaling
- Detergent drawer and housing
- 1. Pull out the detergent drawer. Press down the insert and fully remove the drawer.
- 2. To remove the insert: Push the insert upwards from below with your finger.
- 3. Clean the detergent dispenser tray and insert with water and a brush, and dry it. Clean the inside of the housing as well.
- 4. Fit the insert and lock it in place (push the cylinder onto the guide pin).
- 5. Push in the detergent drawer.
- Note:
- Cleaning the measuring aid A for liquid detergent
- Detergent solution pump blocked
- : Warning
- Risk of scalding!
- 1. Pull out the mains plug.
- 2. Open and remove the maintenance cover.
- 3. Carefully unscrew the pump cover - do not remove it completely. Let the water drain into a shallow container. Repeat the operation until there is no water left.
- 4. Remove the pump cover. Remove foreign material/fluff from inside the pump. Clean the interior, pump cover thread and pump housing (the fan impeller in the detergent-solution pump must be able to rotate).
- 5. Refit the pump cover, ensuring it fits tightly. Handle should be vertical.
- 6. Insert the maintenance cover and close it.
- Note:
- The drain hose at the siphon is blocked
- Filter in the water supply is blocked
- 1. Turn off the tap.
- 2. Select any program (except Spin/ Drain ).
- 3. Press the A button. Allow the program to run for approximately 40 seconds.
- 4. Turn the program selector to off position. Pull out the mains plug.
- 5. Clean the filter on the tap:
- 6. Remove the hose from the rear of the appliance.
- 7. Insert the filter, connect the hose and check for leaks.
- 3 Faults and what to do about them
- Risk of scalding!
- : Warning
- : Warning
- If the laundry has to be removed, the washing machine door can be opened as follows:
- 1. Pull out the mains plug.
- 2. Open and remove the service flap.
- 3. Insert the cross-head screwdriver into the emergency release. Pull it downwards to the end (not less than 1cm).
- 4. Release it.
- 5. The washing machine door can now be opened.
- Information on the display panel
- Faults and what to do about them
2SHUDWLQJWKHDSSOLDQFH HQ
0HDVXUHDQGDGGGHWHUJHQW
DQGFDUHSURGXFWV
&DXWLRQ
'DPDJHWRWKHDSSOLDQFH
&OHDQLQJDJHQWVDQGDJHQWVIRUSUH
WUHDWLQJODXQGU\HJVWDLQUHPRYHUV
SUHZDVK VSUD\V HWF PD\ FDXVH GDPDJH
LIWKH\FRPHLQWRFRQWDFWZLWKWKH
VXUIDFHVRIWKHZDVKLQJPDFKLQH
'RQRWDOORZWKHVHDJHQWVWRFRPHLQWR
FRQWDFWZLWKWKHVXUIDFHVRIWKHZDVKLQJ
PDFKLQH,IQHFHVVDU\LPPHGLDWHO\ZLSH
DZD\VSUD\UHVLGXHDQGRWKHUUHVLGXHV
GURSOHWVZLWKDGDPSFORWK
'RVLQJ
'RVHWKHGHWHUJHQWVDQGFDUHSURGXFWV
DFFRUGLQJWR
■ :DWHUKDUGQHVVDVN\RXUZDWHU
VXSSO\FRPSDQ\
■ 7KH PDQXIDFWXUHUV LQVWUXFWLRQV RQ WKH
SDFNDJLQJ
■ 7KHDPRXQWRIODXQGU\
■ 6RLOLQJ
)LOOLQJ
::DUQLQJ
(\HVNLQLUULWDWLRQ
'HWHUJHQWVDQGFDUHSURGXFWVPD\VSUD\
RXWLIWKHGHWHUJHQWGUDZHULVRSHQHG
ZKLOHWKHPDFKLQHLVLQRSHUDWLRQ
2SHQWKHGUDZHUFDUHIXOO\
5LQVHH\HVVNLQWKRURXJKO\LIWKH\FRPH
LQWRFRQWDFWZLWKGHWHUJHQWVRUFDUH
SURGXFWV
,IDFFLGHQWDOO\VZDOORZHGVHHNPHGLFDO
DGYLFH
1RWH 'LOXWHYLVFRXVIDEULFVRIWHQHUDQG
IDEULFFRQGLWLRQHUZLWKDOLWWOHZDWHU7KLV
SUHYHQWVEORFNDJHVLQWKHZDVKLQJ
PDFKLQHVSLSLQJ
3RXU WKH GHWHUJHQW DQG FDUH SURGXFWV LQWR
WKHDSSURSULDWHFRPSDUWPHQWV
GHSHQGLQJRQWKHPRGHO
1. 3XOO RXW WKH GHWHUJHQW GUDZHU DV IDU DV
SRVVLEOH
2. $GGGHWHUJHQWDQGRUFDUHSURGXFWV
3. &ORVHWKHGHWHUJHQWGUDZHU
0HDVXULQJDLG
IRUOLTXLGGHWHUJHQW
3RVLWLRQ WKH PHDVXULQJ DLG IRU GRVLQJ WKH
FRUUHFWDPRXQWRIOLTXLGGHWHUJHQW
1. 3XOORXWWKHGHWHUJHQWGUDZHU,QVHUW
WKH PHDVXULQJ DLG LQWR FRPSDUWPHQW ,,
IRUPDLQZDVK
2. 3RXUOLTXLGGHWHUJHQWLQWRPHDVXULQJ
DLGDQGGRQRWH[FHHGWKHPD[LPXP
PDUN
3. 5HLQVHUWWKHGUDZHU
0HDVXULQJDLG $ )RUOLTXLGGHWHUJHQW
&RPSDUWPHQW ,, 'HWHUJHQWIRUWKH
PDLQZDVKZDWHU
VRIWHQHU EOHDFK VWDLQ
UHPRYHU
&RPSDUWPHQW i )DEULF VRIWHQHU OLTXLG
VWDUFK
GRQRWH[FHHG PD[
&RPSDUWPHQW , 'HWHUJHQW IRU SUHWUHDW
DQGFORWKLQJ
GLVLQIHFWDQWRQO\IRU
WKHDSSOLDQFHZLWK
SUHWUHDWDQG
GLVLQIHFWDQWIXQFWLRQ
GHSHQGLQJRQWKHPRGHO
0$;