User manual

Cleaning and maintenance en
33
:Warning
Risk of scalding!
Washing water is hot when washing at
high temperatures. You may be scalded
if you touch the hot washing water.
Allow the washing water to cool down.
1. Pull out the mains plug.
2. Open and remove the maintenance
cover.
3. Carefully unscrew the pump cover -
do not remove it completely. Let the
water drain into a shallow container.
Repeat the operation until there is no
water left.
4. Remove the pump cover. Remove
foreign material/fluff from inside the
pump. Clean the interior, pump
cover thread and pump housing (the
fan impeller in the detergent-solution
pump must be able to rotate).
5. Refit the pump cover, ensuring it fits
tightly. Handle should be vertical.
6. Insert the maintenance cover and
close it.
Note: To prevent unused detergent
from flowing into the outlet during the
next wash: Pour 1 litre of water into
dispenser II and start the Single spin
programme.
The drain hose at the siphon
is blocked
1. Switch off the appliance. Disconnect
the mains plug.
2. Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3. Clean the drain hose and siphon
connecting piece.
4. Reattach the drain hose and secure
the connection using the hose
clamp.
Filter in the water supply is
blocked
First, reduce the water pressure in the
supply hose:
1. Turn off the tap.
2. Select any program (except Single
spin).
3. Press the A button. Allow the
program to run for approximately 40
seconds.
4. Turn the program selector to off
position. Pull out the mains plug.
5. Clean the filter on the tap:
Disconnect the hose from the tap.
Clean the filter with a small brush.
6. Remove the hose from the rear of
the appliance.