User's Manual
Table Of Contents
- en Instruction Manual and Installation Instructions
- Display rules
- : Warning!
- Caution!
- Note/tip
- 1. 2. 3. / a) b) c)
- Contentsen Instruction Manual and Installation Instructions
- 8 Intended use 5
- ( Safety instructions 5
- 7 Environmental protection 11
- 5 Positioning and connecting 12
- * Familiarising yourself with your appliance 20
- Z Laundry 24
- C Detergent 25
- / Programme overview 26
- 0 Programme default settings 29
- \ Additional programme settings 30
- 1 Operating the appliance 32
- a Intelligent dosing system 35
- Q Appliance settings 41
- H Sensors 42
- 2 Cleaning and maintenance 42
- 3 Faults and what to do about them. 45
- [ Consumption values 50
- J Technical data 52
- 4 After-sales service 52
- r Aqua-Stop warranty 53
- 8 Intended use
- Intended use
- ( Safety instructions
- Safety instructions
- Children/people/pets
- Installation
- : Warning
- Risk of electric shock/fire/ material damage/damage to the appliance!
- : Warning
- Risk of electric shock/fire/ material damage/damage to the appliance!
- : Warning
- Risk of fire/material damage/ damage to the appliance!
- : Warning
- Risk of injury/material damage/damage to the appliance!
- : Warning
- Risk of injury!
- Caution!
- Operation
- Cleaning/Maintenance
- 7 Environmental protection
- 5 Positioning and connecting
- Positioning and connecting
- Included with the appliance
- Safety instructions
- Installation surface
- Installation on a base or a wooden joist floor
- Installation on a platform with drawer
- Installing the appliance in a kitchenette
- Removing the transport locks
- 2. Unscrew and remove all four transport brace screws.
- 3. Fit the covers. Lock the covers firmly in place by applying pressure to the snap-in hooks.
- Connection
- Connection
- Preparatory work:
- Run the program without laundry:
- 1. Switch on the appliance.
- 2. Close the door (do not load any laundry).
- 3. Set the Drum Clean Û 90 °C program.
- 4. Open the detergent drawer.
- 5. Pour approx. 1 litre of water into the manual dosing compartment.
- 6. Pour all-purpose detergent into the manual dosing compartment.
- 7. Close the detergent drawer.
- 8. Start the program.
- 9. Switch off the appliance once the program has finished.
- 2. Release the water pressure in the supply hose: ~ "Filter in the water supply blocked" on page 44
- 3. Disconnect the washing machine from the mains power supply.
- 4. Drain the remaining water: ~ "The drain pump is blocked, emergency draining" on page 43
- 5. Detach the hoses.
- 6. Empty the dispensers. ~ Page 39
- Fitting the transportation securing means:
- * Familiarising yourself with your appliance
- Familiarising yourself with your appliance
- Washing machine
- Controls
- Content of the touch display
- Z Laundry
- C Detergent
- / Programme overview
- Programme overview
- Programmes and fabrics
- Maximum load size
- Use softener?
- Notes
- Note:
- Notes
- Notes
- Notes
- Note:
- Note:
- Note:
- Possible program settings
- 0 Programme default settings
- \ Additional programme settings
- Additional programme settings
- Aqua Plus
- SpeedPerfect
- Reduced Ironing
- Prewash
- Soaking
- 2. Select the Cottons i 30 °C program and press the A button.
- 3. Press the A button after approx. 10 minutes.The laundry will soak in the water.
- 4. Leave the laundry to soak for as long as required, then either press the A button again to resume the program or change the program.
- 1 Operating the appliance
- Operating the appliance
- Preparing the washing machine
- 2. Turn on the water tap.
- 3. Open the door.
- 4. Check that the drum is completely drained. Drain if necessary.
- You can:
- The current programme information is displayed during the programme:
- Note:
- Child lock 3 sec./operation lock
- Adding laundry
- Changing the programme
- 2. Select another programme.
- 3. And touch A again.The new program starts from the beginning.
- 2. To cool the laundry: Select Rinse.
- 3. And touch A again.
- 2. Select Spin or Drain.
- 3. And touch A again.
- 2. Switch off the appliance.
- 3. Turn off the tap.
- a Intelligent dosing system
- Intelligent dosing system
- Familiarising yourself with i- DOS
- i-DOS Detergent drawer
- Before setting up i-DOS
- Automatic dosing
- The automatic dosage operates as follows:
- Set the dispenser content as follows:
- Check whether the preset basic dosages follow the manufacturer's recommendations in terms of:
- Below is an example of detergent dosages on a packaging label:
- Adjusting the basic dosage
- Fill the dispensers as follows:
- Dosing and adding detergent
- Note:
- 2. Pour laundry detergent and/or care product into the manual dosing compartment.
- 3. Push in the detergent drawer.
- 2. Pull out the detergent drawer.
- 3. Press down the insert and remove the drawer completely.
- 4. Press the pump unit insert and remove it.
- 5. Unclip the rear detergent drawer lid and remove it.
- 6. Empty the detergent drawer.
- 7. Clean the pump unit with a damp cloth.
- 8. Clean the drawer, inside surface and lids with a soft, damp cloth or a hand shower.
- 9. Dry the drawer, lids and pump unit and put them back together.
- 10. Clean the inside of the detergent drawer housing.
- 11. Push in the detergent drawer.
- Q Appliance settings
- H Sensors
- 2 Cleaning and maintenance
- Cleaning and maintenance
- : Warning
- Danger of death!
- : Warning
- Risk of poisoning!
- Caution!
- Damage to the appliance
- Notes
- Machine housing/control panel
- Drum
- Descaling
- The drain pump is blocked, emergency draining
- 2. Switch off the appliance.Pull out the mains plug.
- 3. Open and remove the service flap.
- 4. Take the drain hose out of the holder.
- 5. Carefully unscrew the pump cover, as residual water may leak out.
- 6. Reinsert the bottom of the service flap into the slot, clip it into place and close the flap.
- 2. Loosen the hose clamp. Carefully remove the drain hose; residual water may leak out.
- 3. Clean the drain hose and siphon connecting piece.
- 4. Re-attach the drain hose and secure the connection point using the hose clamp.
- 2. Clean the filters:
- 3 Faults and what to do about them.
- [ Consumption values
- J Technical data
- 4 After-sales service
- r Aqua-Stop warranty
- Aqua-Stop warranty
- 2. The liability guarantee is valid for the service life of the appliance.
- 3. It is a prerequisite of all warranty claims that the appliance with Aqua- Stop must have been installed and connected correctly in accordance with our instructions; this also includes a correctly fitted Aqua-Stop extension (genuine accessories).
- 4. Appliances with Aqua-Stop do not need to be supervised during operation, nor secured afterwards by turning off the tap.
Programme overview en
27
Rinse / Spin / Drain ' / 0 / [
Combined programme: Rinses and then spins the laundry, and
then pumps out the water.
Notes
■ The Rinse programme, after which the laundry is spun and
the water is pumped out, has been preactivated.
■ If you only want to rinse the laundry and pump out the water,
set the spin speed to 0.
■ If you only want to spin the laundry and pump out the water,
deactivate the Rinse Plus O setting.
■ If you only want to pump out the water, deactivate the Rinse
Plus O setting and set the spin speed to 0.
~ Yes when using
the Rinse pro-
gramme
Drum Clean Û
Programme for cleaning and caring for the drum, e.g.:
■ Before using the appliance for the first time
■ If you regularly wash at temperatures of 40 °C or lower, or
■ If you have been away for an extended period and odours
have built up.
The drum cleaning indicator will flash to remind you if you have
not used a programme at 60 °C or higher for a long time.
Notes
■ Run the programme without laundry.
■ Use standard washing powder or a detergent that contains
a bleaching agent. Halve the amount of detergent to reduce
foaming.
■ Do not use liquid detergent or detergent that is intended for
woollens or delicates.
0 kg No
Super Quick 15’ / 30’ + / ,
SuperQuick programmes lasting approx. 15/30 minutes for
items made from cotton or synthetic or blended fabrics.
Suitable for lightly soiled laundry.
Note: If you want to use the Super Quick 15' programme, acti-
vate the SpeedPerfect setting.
2/4 kg Yes
Shirts/Blouses ‹
Non-iron shirts/blouses made from cotton, linen, or synthetic or
blended fabrics.
Shirts/blouses are only given a short spin with the Reduced
Ironing Q setting. They can then be hung up to dry while still
dripping wet. The self-smoothing effect eliminates or reduces
the need for ironing.
Note: Use the Delicates/Silk programme to wash shirts/blouses
made from silk or delicate fabrics.
2 kg Yes