Operating/installations instructions

en Faults and what to do about them

Information on the display panel

Display Cause/Remedy

Õ ■ Flashes fast + signal: The door was opened and the water level is too high.

Close the door, continue the programme with A button or select 0 pro-

gramme.

■ Flashes slowly: The door lock temperature is too high to open the door. Wait

approx. 30 seconds until the door lock temperature cools down.

Hot The door cannot be opened after the drying programme due to the high tempera-

ture. The cooling process continues until the display disappears, after which the

door can be opened.

r ■ Flashes (no water supply): Water tap turned on? Filter in the water supply is

blocked?

~ "Filter in the water supply is blocked" on page 46

Is the supply hose kinked or trapped?

■ Lights up (low water pressure): For information only. This will not affect the

programme progress. The programme duration is extended.

E:3610 E:36 alternating display with -10 and End when programme is finished:

■ The drain pump is blocked.

~ "Drain pump is blocked" on page 45

■ The drain hose at the siphon is blocked.

~ "The drain hose at the siphon is blocked" on page 46

H:95 H:95 alternating display with End when programme is finished: no water detected

in drying phase, may get bad drying result.

H:32 H:32 alternating display with End when programme is finished: unbalance prob-

lem, spinning phase is aborted.

E (3s) lights up The childproof lock is activated – deactivate it.

Å lights up Too much foam has been detected and an additional wash cycle has been acti-

vated. Add less detergent to the next washing cycle with the same load.

The indicator lamp of

the Û Limp. tam-

bor (Drum Clean)

programme flashes

Run the Û Limp. tambor (Drum Clean) 90°C programme to clean and care for

the drum and the outer tub.

Notes

■ Run the programme without laundry.

■ Use washing powder or a detergent containing bleach. To prevent foaming,

only use half the amount of detergent recommended by the detergent manu-

facturer. Do not use detergent designed for woollens or delicates.

■ Switching the Û Limp. tambor (Drum Clean) information signal on/off.

~ "Switching the drum-care information signal on/off" on page 42

Other displays Switch off the appliance, wait for five seconds and then switch it on again. If the dis-

play appears again, call customer service.