Installation Instruction
Table Of Contents
- en Instruction Manual and Installation Instructions
- Display rules
- : Warning!
- Caution!
- Note/tip
- 1. 2. 3. / a) b) c)
- Contentsen Instruction Manual and Installation Instructions
- 8 Intended use 4
- ( Safety instructions 5
- 7 Environmental protection 12
- 5 Positioning and connecting 13
- * Getting to know the appliance 22
- Z Laundry 25
- C Detergents and care products 27
- P Overview of programmes 29
- 0 Programme default settings 36
- \ Additional programme settings 38
- 1 Operating the appliance 40
- o Home Connect 45
- Q Appliance settings 51
- H Sensors 52
- 2 Cleaning and maintenance 52
- 3 Faults and what to do about them 56
- 4 Customer Service 63
- [ Consumption values 65
- J Technical data 66
- r Aqua-Stop warranty 66
- 8 Intended use
- Intended use
- ( Safety instructions
- Safety instructions
- Children/people/pets
- Installation
- : Warning
- Risk of electric shock/fire/ material damage/damage to the appliance!
- : Warning
- Risk of electric shock/fire/ material damage/damage to the appliance!
- : Warning
- Risk of fire/material damage/ damage to the appliance!
- : Warning
- Risk of injury/material damage/damage to the appliance!
- : Warning
- Risk of injury!
- Caution!
- Operation
- Cleaning/Maintenance
- 7 Environmental protection
- 5 Positioning and connecting
- Positioning and connecting
- Standard accessories
- Safety instructions
- Installation surface
- Installation on a base or a wooden joist floor
- Installing the appliance in a kitchenette
- Removing the transport locks
- 1. Take the hoses out of the holders.
- 2. Unscrew and remove all four transport brace screws.
- 3. Fit the covers.
- 4. Lock the covers firmly in place by applying pressure to the snap-in hooks.
- 1. Unscrew and remove all screws in the vertical transport struts.
- 2. Remove the transport struts.
- 3. Undo and remove the screws on the horizontal transport strut.
- 4. Remove the transport strut.
- 1. Connect the water supply hose to the water tap (¾" = 26.4 mm) and to the appliance:
- 2. Open the water tap carefully, checking the leak tightness of the connection points. The screw connection is under mains water pressure.
- 1. Loosen the lock nuts using a wrench, by turning it in a clockwise direction.
- 2. Check the alignment of the appliance with a spirit level, and adjust it if necessary. Change the height by turning the appliance feet.
- 3. Tighten the lock nut against the housing.
- 1. Insert mains plug.
- 2. Turn the water tap on.
- 3. Press the # button till the indicator lamp lights up, release the button. The appliance is switched on.
- 4. Close the door. Do not load any laundry.
- 5. Select the Drum Clean 90°C programme.
- 6. Open the detergent drawer.
- 7. Pour approx. 1 litre of water into dispenser II.
- 8. Add standard detergent to dispenser II according to manufacturer’s instructions for light soiling.
- 9. Close the detergent drawer.
- 10. Select A.
- 11. When the programme ends, press the # button till the indicator lamp turns off, release the button.
- 1. Turn off the water tap.
- 2. Reduce the water pressure in the supply hose. ~ Page 55
- 3. Drain any residual water. ~ Page 54
- 4. Disconnect the appliance from the mains.
- 5. Remove the hoses.
- 6. Empty the dispensers. ~ "Detergent drawer and housing" on page 53
- 1. Remove the covers and keep them in a safe place.
- 2. Insert all four sleeves.
- * Getting to know the appliance
- Getting to know the appliance
- Appliance
- Control panel
- Touch-Display
- Programme default settings
- Additional programme settings
- Status indicators for the programme progress (programme sequence)
- Further settings
- Z Laundry
- C Detergents and care products
- P Overview of programmes
- 0 Programme default settings
- Programme default settings
- Temperature
- Spin speed
- Finish in
- To do this:
- 1. Select a programme (except My Time programme).
- 2. Select the ˜ button repeatedly until the required number of hours is displayed.
- 3. Select the A button.
- 1. Select the A button.
- 2. Touch the ˜ or ~ button to change the number of hours.
- 3. Select the A button.
- \ Additional programme settings
- Additional programme settings
- Note:
- Speed
- T (Prewash)
- O (Rinse plus)
- 2 (Hygiene care)
- p (Easy iron)
- Z (Water plus)
- â (Memory)
- To store:
- 1. Switch on the appliance.
- 2. Select a programme.
- 3. If required, change the programme default settings and/or select programme additional settings.
- 4. Touch and hold â (Memory) button for approx. three seconds.
- 1 Operating the appliance
- Operating the appliance
- Preparing the appliance
- 1. Insert mains plug.
- 2. Turn the water tap on.
- 3. Open the appliance door.
- 1. Connect the appliance to your home network and the Home Connect app.
- 2. Select ... further programme.
- 3. Select the desired programme on the Home Connect app.
- 4. If necessary, adjust programme settings and touch the A button.
- 1. Pull out the detergent drawer.
- 2. Pour in detergent and/or cleaning product.
- 1. Pull out the detergent drawer. Press down the insert and fully remove the drawer.
- 2. Slide the measuring aid forwards, fold it down and click it into place.
- 3. Reinsert the drawer.
- 1. Touch the A button.
- 2. Select another programme.
- 3. And touch the A button again. The new programme starts from the beginning.
- 1. Touch the A button.
- 2. To cool down laundry: Select Rinse.
- 3. Touch the A button.
- 1. Touch the A button.
- 2. Select Spin.
- 3. Touch the A button.
- 1. Switch the appliance off.
- 2. Switch the appliance on again.
- 3. To cool down laundry: Select the My Time + Dry.
- 4. Touch the A button.
- 1. Press the # button till the indicator lamp turns off, release the button. The appliance is switched off.
- 2. Open the door and remove the laundry.
- 3. Turn off the water tap.
- o Home Connect
- Home Connect
- 1. Install the Home Connect app on your mobile device.
- 2. Register in the Home Connect app.
- 3. Connect your appliance to your home network automatically or manually (you only need to do this the first time).
- 4. Connect your appliance to the Home Connect app.
- 1. Switch on the appliance.
- 2. Press and hold } (Remote start) } for at least 3 seconds.
- Connecting to your home network automatically
- Connecting to your home network manually
- 1. Set the programme to position 2.
- 2. Press A.
- 3. Call up the Wi-Fi setting on the mobile device.
- 4. Connect the mobile device to the Home Connect Wi-Fi network and enter the password (key) HomeConnect.
- 5. Once you have connected successfully, open the Home Connect app on your mobile device and carry out the steps in the app.
- 6. In the Home Connect app, enter the network name (SSID) and password (key) for your home network.
- 7. Carry out the last steps in the Home Connect app to connect your appliance.
- Connecting to the Home Connect app
- 1. Set the programme to position 3.
- 2. Press A.
- 3. Once your appliance is displayed in the app, carry out the last steps in the Home Connect app.
- 1. Set the programme to position 4.
- 2. Press A.
- 1. Set the programme to position 5.
- 2. Press A.
- 3. Press A.
- 1. Set the programme to position 6.
- 2. Press A.
- 3. Press A.
- Q Appliance settings
- H Sensors
- 2 Cleaning and maintenance
- Cleaning and maintenance
- : Warning
- Risk of death!
- Caution!
- Fire and explosion hazard!
- Caution!
- The appliance may be damaged!
- Appliance housing/control panel
- Drum
- Descaling
- Detergent drawer and housing
- If the appliance contains detergent or fabric softener residues:
- 1. Pull out the detergent drawer. Press down the insert and fully remove the drawer.
- 2. To remove the insert: Push the insert upwards from below with your finger.
- 3. Clean the detergent dispenser tray and insert with water and a brush, and dry it. Clean the inside of the housing as well.
- 4. Fit the insert and lock it in place (push the cylinder onto the guide pin).
- 5. Push in the detergent drawer.
- 1. Switch off the appliance. Pull out the mains plug.
- 2. Open the service flap.
- 3. Take the drain hose out of the retainer.
- 4. Carefully unscrew the pump cover; residual water may leak out.
- 5. Refit and screw on the pump cover. The handle must be in a vertical position.
- 6. Close the service flap.
- 1. Press the # button. Pull out the mains plug.
- 2. Loosen the hose clamp. Carefully remove the drain hose; residual water may leak out.
- 3. Clean the drain hose and siphon connecting piece.
- 4. Re-attach the drain hose and secure the connection point using the hose clamp.
- 1. Turn off the water tap.
- 2. Select the Cotton (activate Speed setting) programme.
- 3. Select the A button. Allow the programme to run for approx. 40 seconds.
- 4. Press the button #.
- 5. Pull out the mains plug.
- 1. Disconnect the hose from the rear of the appliance.
- 2. Use pliers to remove the filter.
- 3. Clean the filter with a small brush.
- 4. Connect the hose and check for leaks.
- 3 Faults and what to do about them
- Faults and what to do about them
- Emergency release
- However, if the laundry has to be removed, the appliance door can be opened as follows:
- 1. Press the # button. Pull out the mains plug.
- 2. Open the service flap.
- 3. Drain the water. ~ Page 54
- 4. Pull the emergency release downwards with a tool and release.
- 4 Customer Service
- [ Consumption values
- J Technical data
- r Aqua-Stop warranty
- Aqua-Stop warranty
- In addition to warranty claims against the vendor based on the purchase agreement and to our appliance warranty, we will provide compensation under the following conditions:
- 1. If water damage is caused due to a fault in our Aqua-Stop system, we will compensate domestic customers for the damage caused.
- 2. The liability guarantee is valid for the service life of the appliance.
- 3. It is a prerequisite of all warranty claims that the appliance with Aqua- Stop must have been installed and connected correctly in accordance with our instructions; this also includes a correctly fitted Aqua-Stop extension (genuine accessories).
- 4. Appliances with Aqua-Stop do not need to be supervised during operation, nor secured afterwards by turning off the tap.
en Laundry
26
Sorting laundry
Sort your laundry according to the care
instructions and manufacturer's
information on the care labels,
depending on:
■ Type of fabric/fibre
■ Colour
Note: Laundry may discolour. Wash
white and coloured items separately.
Wash new coloured items separately
the first time you wash them.
■ Soiling
Wash laundry with the same level of
soiling together.
Some examples of soiling levels can
be found in the chapter
– Light: Do not need to pretreat,
adjust the Speed setting if
necessary.
– Normal
– Heavy: Load less laundry, need
to pretreat or soak laundry firstly.
– Stains: Remove/pretreat stains
while they are fresh. First dab
with soapy water; do not rub.
Then wash the items of laundry
with the appropriate programme.
Stubborn or dried-in stains can
sometimes only be removed by
washing several times.
■ Symbols on the care labels
Preparing laundry for drying
Note: To ensure an even drying result,
sort the laundry according to the:
■ Type of fabric
■ Care symbols which are indicated on
the care labels.
Only dry laundry which is labelled
“dryer-proof” or which has the following
care symbols:
■ a : You can select
Cotton + Dry
■ ` : You can select
Mix+ Dry
The following textiles should not be
dried:
■ b = care symbol “Do not dry”
■ Delicates (silk, synthetic curtains).
■ Textiles which contain foam rubber
or similar materials.
■ Textiles which were treated with
flammable liquids, e.g. with stain
remover, petroleum ether, thinners.
Risk of explosion!
■ Textiles which still contain hairspray
or similar substances.
Notes
■ Before drying, hand-washed textiles
must be spun at the appropriate spin
speed.
■ Before drying, spin at the optimum
speed. A spin speed of more than
1000 rpm is recommended for
cotton, more than 800 rpm for easy-
care textiles.
■ Do not iron washing immediately
after drying. It is recommended to
roll the washing up first to distribute
residual moisture evenly.
■ To ensure a good drying
performance, quilts, terry cloths and
other large textiles should be dried
separately. Do not dry more than 6
terry cloths (or 5 kg).
■ Do not exceed the maximum load.
M Suitable for normal washing
process;
e.g. Cotton programme
N A gentle washing process is
required;
e.g. Easy Care programme
O An especially gentle washing
process is required;
e.g. Delicate/Silk programme
W Suitable for washing by hand;
e.g. W Wool/Handwash
programme
Ž Do not machine wash.