Installation Instruction
Table Of Contents
- en Instruction Manual and Installation Instructions
- Display rules
- : Warning!
- Caution!
- Note/tip
- 1. 2. 3. / a) b) c)
- Contentsen Instruction Manual and Installation Instructions
- 8 Intended use 4
- ( Safety instructions 5
- 7 Environmental protection 12
- 5 Positioning and connecting 13
- * Getting to know the appliance 22
- Z Laundry 25
- C Detergents and care products 27
- P Overview of programmes 29
- 0 Programme default settings 36
- \ Additional programme settings 38
- 1 Operating the appliance 40
- o Home Connect 45
- Q Appliance settings 51
- H Sensors 52
- 2 Cleaning and maintenance 52
- 3 Faults and what to do about them 56
- 4 Customer Service 63
- [ Consumption values 65
- J Technical data 66
- r Aqua-Stop warranty 66
- 8 Intended use
- Intended use
- ( Safety instructions
- Safety instructions
- Children/people/pets
- Installation
- : Warning
- Risk of electric shock/fire/ material damage/damage to the appliance!
- : Warning
- Risk of electric shock/fire/ material damage/damage to the appliance!
- : Warning
- Risk of fire/material damage/ damage to the appliance!
- : Warning
- Risk of injury/material damage/damage to the appliance!
- : Warning
- Risk of injury!
- Caution!
- Operation
- Cleaning/Maintenance
- 7 Environmental protection
- 5 Positioning and connecting
- Positioning and connecting
- Standard accessories
- Safety instructions
- Installation surface
- Installation on a base or a wooden joist floor
- Installing the appliance in a kitchenette
- Removing the transport locks
- 1. Take the hoses out of the holders.
- 2. Unscrew and remove all four transport brace screws.
- 3. Fit the covers.
- 4. Lock the covers firmly in place by applying pressure to the snap-in hooks.
- 1. Unscrew and remove all screws in the vertical transport struts.
- 2. Remove the transport struts.
- 3. Undo and remove the screws on the horizontal transport strut.
- 4. Remove the transport strut.
- 1. Connect the water supply hose to the water tap (¾" = 26.4 mm) and to the appliance:
- 2. Open the water tap carefully, checking the leak tightness of the connection points. The screw connection is under mains water pressure.
- 1. Loosen the lock nuts using a wrench, by turning it in a clockwise direction.
- 2. Check the alignment of the appliance with a spirit level, and adjust it if necessary. Change the height by turning the appliance feet.
- 3. Tighten the lock nut against the housing.
- 1. Insert mains plug.
- 2. Turn the water tap on.
- 3. Press the # button till the indicator lamp lights up, release the button. The appliance is switched on.
- 4. Close the door. Do not load any laundry.
- 5. Select the Drum Clean 90°C programme.
- 6. Open the detergent drawer.
- 7. Pour approx. 1 litre of water into dispenser II.
- 8. Add standard detergent to dispenser II according to manufacturer’s instructions for light soiling.
- 9. Close the detergent drawer.
- 10. Select A.
- 11. When the programme ends, press the # button till the indicator lamp turns off, release the button.
- 1. Turn off the water tap.
- 2. Reduce the water pressure in the supply hose. ~ Page 55
- 3. Drain any residual water. ~ Page 54
- 4. Disconnect the appliance from the mains.
- 5. Remove the hoses.
- 6. Empty the dispensers. ~ "Detergent drawer and housing" on page 53
- 1. Remove the covers and keep them in a safe place.
- 2. Insert all four sleeves.
- * Getting to know the appliance
- Getting to know the appliance
- Appliance
- Control panel
- Touch-Display
- Programme default settings
- Additional programme settings
- Status indicators for the programme progress (programme sequence)
- Further settings
- Z Laundry
- C Detergents and care products
- P Overview of programmes
- 0 Programme default settings
- Programme default settings
- Temperature
- Spin speed
- Finish in
- To do this:
- 1. Select a programme (except My Time programme).
- 2. Select the ˜ button repeatedly until the required number of hours is displayed.
- 3. Select the A button.
- 1. Select the A button.
- 2. Touch the ˜ or ~ button to change the number of hours.
- 3. Select the A button.
- \ Additional programme settings
- Additional programme settings
- Note:
- Speed
- T (Prewash)
- O (Rinse plus)
- 2 (Hygiene care)
- p (Easy iron)
- Z (Water plus)
- â (Memory)
- To store:
- 1. Switch on the appliance.
- 2. Select a programme.
- 3. If required, change the programme default settings and/or select programme additional settings.
- 4. Touch and hold â (Memory) button for approx. three seconds.
- 1 Operating the appliance
- Operating the appliance
- Preparing the appliance
- 1. Insert mains plug.
- 2. Turn the water tap on.
- 3. Open the appliance door.
- 1. Connect the appliance to your home network and the Home Connect app.
- 2. Select ... further programme.
- 3. Select the desired programme on the Home Connect app.
- 4. If necessary, adjust programme settings and touch the A button.
- 1. Pull out the detergent drawer.
- 2. Pour in detergent and/or cleaning product.
- 1. Pull out the detergent drawer. Press down the insert and fully remove the drawer.
- 2. Slide the measuring aid forwards, fold it down and click it into place.
- 3. Reinsert the drawer.
- 1. Touch the A button.
- 2. Select another programme.
- 3. And touch the A button again. The new programme starts from the beginning.
- 1. Touch the A button.
- 2. To cool down laundry: Select Rinse.
- 3. Touch the A button.
- 1. Touch the A button.
- 2. Select Spin.
- 3. Touch the A button.
- 1. Switch the appliance off.
- 2. Switch the appliance on again.
- 3. To cool down laundry: Select the My Time + Dry.
- 4. Touch the A button.
- 1. Press the # button till the indicator lamp turns off, release the button. The appliance is switched off.
- 2. Open the door and remove the laundry.
- 3. Turn off the water tap.
- o Home Connect
- Home Connect
- 1. Install the Home Connect app on your mobile device.
- 2. Register in the Home Connect app.
- 3. Connect your appliance to your home network automatically or manually (you only need to do this the first time).
- 4. Connect your appliance to the Home Connect app.
- 1. Switch on the appliance.
- 2. Press and hold } (Remote start) } for at least 3 seconds.
- Connecting to your home network automatically
- Connecting to your home network manually
- 1. Set the programme to position 2.
- 2. Press A.
- 3. Call up the Wi-Fi setting on the mobile device.
- 4. Connect the mobile device to the Home Connect Wi-Fi network and enter the password (key) HomeConnect.
- 5. Once you have connected successfully, open the Home Connect app on your mobile device and carry out the steps in the app.
- 6. In the Home Connect app, enter the network name (SSID) and password (key) for your home network.
- 7. Carry out the last steps in the Home Connect app to connect your appliance.
- Connecting to the Home Connect app
- 1. Set the programme to position 3.
- 2. Press A.
- 3. Once your appliance is displayed in the app, carry out the last steps in the Home Connect app.
- 1. Set the programme to position 4.
- 2. Press A.
- 1. Set the programme to position 5.
- 2. Press A.
- 3. Press A.
- 1. Set the programme to position 6.
- 2. Press A.
- 3. Press A.
- Q Appliance settings
- H Sensors
- 2 Cleaning and maintenance
- Cleaning and maintenance
- : Warning
- Risk of death!
- Caution!
- Fire and explosion hazard!
- Caution!
- The appliance may be damaged!
- Appliance housing/control panel
- Drum
- Descaling
- Detergent drawer and housing
- If the appliance contains detergent or fabric softener residues:
- 1. Pull out the detergent drawer. Press down the insert and fully remove the drawer.
- 2. To remove the insert: Push the insert upwards from below with your finger.
- 3. Clean the detergent dispenser tray and insert with water and a brush, and dry it. Clean the inside of the housing as well.
- 4. Fit the insert and lock it in place (push the cylinder onto the guide pin).
- 5. Push in the detergent drawer.
- 1. Switch off the appliance. Pull out the mains plug.
- 2. Open the service flap.
- 3. Take the drain hose out of the retainer.
- 4. Carefully unscrew the pump cover; residual water may leak out.
- 5. Refit and screw on the pump cover. The handle must be in a vertical position.
- 6. Close the service flap.
- 1. Press the # button. Pull out the mains plug.
- 2. Loosen the hose clamp. Carefully remove the drain hose; residual water may leak out.
- 3. Clean the drain hose and siphon connecting piece.
- 4. Re-attach the drain hose and secure the connection point using the hose clamp.
- 1. Turn off the water tap.
- 2. Select the Cotton (activate Speed setting) programme.
- 3. Select the A button. Allow the programme to run for approx. 40 seconds.
- 4. Press the button #.
- 5. Pull out the mains plug.
- 1. Disconnect the hose from the rear of the appliance.
- 2. Use pliers to remove the filter.
- 3. Clean the filter with a small brush.
- 4. Connect the hose and check for leaks.
- 3 Faults and what to do about them
- Faults and what to do about them
- Emergency release
- However, if the laundry has to be removed, the appliance door can be opened as follows:
- 1. Press the # button. Pull out the mains plug.
- 2. Open the service flap.
- 3. Drain the water. ~ Page 54
- 4. Pull the emergency release downwards with a tool and release.
- 4 Customer Service
- [ Consumption values
- J Technical data
- r Aqua-Stop warranty
- Aqua-Stop warranty
- In addition to warranty claims against the vendor based on the purchase agreement and to our appliance warranty, we will provide compensation under the following conditions:
- 1. If water damage is caused due to a fault in our Aqua-Stop system, we will compensate domestic customers for the damage caused.
- 2. The liability guarantee is valid for the service life of the appliance.
- 3. It is a prerequisite of all warranty claims that the appliance with Aqua- Stop must have been installed and connected correctly in accordance with our instructions; this also includes a correctly fitted Aqua-Stop extension (genuine accessories).
- 4. Appliances with Aqua-Stop do not need to be supervised during operation, nor secured afterwards by turning off the tap.
en Overview of programmes
30
Cotton
Hard-wearing fabrics, heat-resistant fabrics made of cotton or
linen.
10.0 (5.0**) kg/6.0 kg
— - 90 °C
400 - 1400 rpm
Speed, Z (Water plus), p (Easy iron),
2 (Hygiene care), O (Rinse plus), T
(Prewash), â (Memory), Á (Silent)
Wash+Dry è (¾è, »è, öè)
Dry è (¾è, »è, öè)
possible
Easy Care
Textiles made of synthetic materials or blended fabrics.
4.0 kg/2.5 kg
— - 60 °C
400 - 1400 rpm
Speed, Z (Water plus), p (Easy iron),
2 (Hygiene care), O (Rinse plus), T
(Prewash), â (Memory), Á (Silent)
Wash+Dry è (¾è, »è, ö-)
Dry è (¾è, »è, ö-)
possible
Mix
Mixed load of cottons and synthetic fabrics.
4.0 kg/2.5 kg
— - 60 °C
400 - 1400 rpm
Speed, Z (Water plus), p (Easy iron),
2 (Hygiene care), O (Rinse plus), T
(Prewash), â (Memory), Á (Silent)
Wash+Dry è (¾è, »è, öè)
Dry è (¾è, »è, öè)
possible
Programme/Type of laundry Options/Information
* Depending on the model and the programme.
** Reduced load with Speed additional programme setting.
*** The programme can be found in Home Connect app.