Owner manual
Table Of Contents
- Inhaltsverzeichnis
- Entsorgungshinweise
- Sicherheitshinweise und Warnungen
- Umweltschutz / Sparhinweise J Gerät kennenlernen
- Der Programm- und Temperatur-Wähler
- I Funktionstasten (Ein/Aus und , l^usatefunktionen) j
- Programmtabelle
- Wasch-und Pflegemittet
- Erstej; Waschgang
- ^ [waschen
- [Reinigung / Wartung / Frostschutz
- ' Kundendienst
- Wasserablauf
- I Elektrischer Anschluß
- Средства за пранзе и негу
- Припрема1ъе рубл>а за пран»е
- Пран>е
- Кра] програма / Исюъучиванэе машине
- ЧишЬе1ъе/0држава№е/Заштита од мраза
- ЧишЬен>е/0држава1ье/Заштита од плраза
- [Како от1^онити ма1ье сметное
- Смет1ье
- Могучи узроци/ПомоЬ
- Технички сервис !
- Нивелисан>е машине
- Довод воде
- YU
- Одвод воде
- ГЕлектрични приюьучак
- ви
- ри
- ни
- пи
- ни
- яи
- яи
- ри
- ни
- яи
- Contents
- Notes on disposal
- Safety precautions and warnings
- Environmental protection / notes on savings
- Programme and temperature selectors
- I Function buttons (ON / OFF | ; and additional functions) J
- Programme table
- Detergents and fabric-care additives
- [Preparing laundry for washing
- First wash cycle
- Open the door
- (P).
- Cleaning / Maintenance / Frost protection
- I Correcting minor problems yourself
- Problems
- Possible causes / remedies
- J [technical specifications
- I Removing the transit bolts
- ■ Installing the machine ^
- Aligning the machine
GB
Washing End of wash programme /
Switching the machine OFF
Selecting the wash programme
1, Turn the programme selector clockwise until
it reaches the required programme (Fig. (§)),
2, Set the temperature selector to the required
temperature,
3, Press the buttons for any additional func
tions that are required.
Starting the programme
1, Make sure that the door is closed,
A safety switch prevents the machine from
operating when the door is open,
2, Press the ’’ON/OFF” button (Fig, ®), The
red ON indicator light illuminates and the
programme starts.
Programme sequence
The position of the programme selector Indi
cates which stage in the wash programme the
machine is currently at.
Altering the programme
Switch off the machine (press the "ON/OFF”
button). Turn the programme selector clock
wise to the new programme. Switch the ma
chine on again.
All programmes end automatically after the
spin cycle.
If the ’’Rinse hold" button has been pressed,
the programme will stop at the final rinse cycle
and the washing will be left in the final rinse
water.
You then have two options:
• remove the washing while it is dripping-wet
• spin the washing
If you want to take the laundry out dripping-
wet:
1, Switch OFF the machine,
2, Set the programme selector to Pumping
(P).
3, Switch the machine ON again.
The rinse water is pumped out without spin
ning.
If you want to spin the laundry;
O Press the "Rinse hold" button again to re
turn it to its normal position.
The water is then pumped out and the laun
dry is spun.
Switching the machine OFF
1. Press the ’’ON/OFF" button.
The machine is switched off and the power
indicator light goes out,
2. After approx, 2 minutes you will be able to
open the door and remove the washing.
! Remove any foreign objects (paper clips,
coins, etc.) inside the drum or trapped in the
rubber seal, otherwise there is a danger or
rust occurring.
Leave the door open slightly so that the ma
chine can dry out properly.
3. Reset any buttons that were pressed by
pressing them again.
4. Turn the tap OFF!
66