Operating/installations instructions

en Programme default settings
24
0 Programme default
settings
Programme default settings The default program settings are
displayed in the display panel after
selecting the program.
You can change the default settings.
To do this, repeatedly press the
corresponding button until the required
setting is displayed on the display
panel.
Note: Pressing and holding the buttons
automatically runs through the setting
values until the last one. Then press the
button again and you will be able to
change the setting values again.
You can find an overview of all possible
program settings on the supplementary
sheet for the installation and operating
instructions.
Temperature
(°C, Temp. °C)
Button depending on the model
Depending on what stage the program
is in, you can change the set
temperature before and during the
program.
The maximum temperature that can be
set depends on the program that has
been selected.
rpm/Spin speed
(0, rpm, 0)
Depending on what stage the program
is in, you can change the spin speed (in
rpm; revolutions per minute) before and
during the program.
Setting 0: The rinsing water is drained
but there is no final spin. The laundry
stays wet inside the drum, e.g. for items
that should not be spun.
Setting - - - -: Spülstopp (Rinse Stop) =
no final spin. The laundry stays in the
water after the final rinse.
You can select "Spülstopp" (Rinse Stop)
to prevent creasing if the laundry will not
be taken out of the washing machine
immediately after the program has
ended.
To continue/end the program
~ Page 29
The maximum speed that can be set
depends on the model and program
that has been selected.
Finished in-time
(ñ, Finished in-time ñ)
Before starting the program, you can
preselect the program end ("Fertig in"
["Ready in"] time) in hourly increments
(h = hour) up to a maximum of 24
hours.
To do this:
1. Select a program.
The program duration is displayed
for the selected program, e.g. 2:30
(hours:minutes).
2. Press the Finished in-time button
repeatedly until the required number
of hours is displayed.
3. Press the A button.
The program starts.
The selected number of hours (e.g.
8 h) is shown in the display panel
and counts down until the wash
program starts. The duration of the
program is then displayed.
Note: The length of the program is
automatically adjusted when the
program is running.
Certain factors can affect the program
length, e.g.:
■ Program settings,
■ Detergent dosage (additional rinse
cycles if required due to foaming),
■ Load size/type of textiles (water
absorption differs),