Operating/installations instructions

20
Cleaning and care

Danger of electric shock!
Completely disconnect the washing
machine from the mains.
Never clean the washing machine with a
jet of water.

Danger of explosion!
Never use solvents for cleaning.

Danger of freezing
If there is danger of freezing, remove the
water-inlet hose from the tap and empty
the water from the drain hose and the
machine
.
Cabinet
Use only soap and water.
Control panel, base, etc.:
Use only a moist towel.
Do not use:
• Scouring powder
• Metal pads or plastic sponges
• Alcohol-based products (alcohol, diluents,
etc.)
Interior components
It is suggested:
• To leave the lid open for some time after
washing.
• To clean the plastic and rubber parts of
the washtub inlet about once a month with
soapy water.Rinse thoroughly to remove
all traces of this cleaning material.
• It is suggested that the 90°C washing
programme be run at regular intervals.
Detergent dispenser
Clean the detergent dispenser regularly. For
this purpose:
- To remove the detergent dispenser,
squeeze both pressure points
simultaneously (
Figure 10 ). The dispenser
then detaches itself from the chamber
(Figure 10) .
- Remove components

at the rear of the
dispenser and separate from the front cover

(Figure 11) .
- Rinse the parts under running water.
Completely empty the dispenser.
- Reassemble all components in the proper order.
Snap the detergent chamber into place under
the lid of the washing machine.
Figure 10
Figure 11

