Operation Manual

9
1. Pull out the mains plug.
2. Open the door.
3. Using a screwdriver, turn the contact
pin on the inside of the door (top)
through 90 degrees and take it out.
4. Remove the two screws from the door
hinge and take the door off.
5. Remove the two screws above and
below the door lock.
6. To remove the door latch: use a
screwdriver to press down on the
small rib in the upper opening and pull
the door latch out forwards.
7. To change the door stop:
• Turn the door.
• Using the two screws, fix the door
hinge on the desired side.
• Attach the door latch on the opposite
side.
• Snap the door latch into place.
• Screw the two screws above and
below the door latch tight.
8. Re-insert the contact pin in the inside
of the door (top).
Door reversibility