Operat./Install.Instruct./Program table
c @c c
L
I
c c÷@c
+ @
+ @
L
a+ c + c
a
a
a
9
Technical data
Dimensions (DxWxH) 60 x 60 x 85 cm
Weight approximately 35 kg
Max. capacity 7 kg
Condensation container approx. 4.2 l
Ambient temperature 5 - 35 °C
Connection voltage 220 V
Connected load 2300 W
Fuse protection 13 A
Product number
a Rating plate or inside of the door
Production number
You can find the rating plate on the back of the dryer.
ʠ
Consumption rates
These are guide values determined under standard
conditions. Deviations of up to 10 % are possible. The value
on the label is achieved at the maximum heat setting.
Spin speed in rpm
(residual moisture)
Drying time** in
minutes, includ-
ing 8 minutes
cool cycle
Energy
consumption**
in kWh
L Cottons 7 kg
+. Cupboard* 1400 (aprox. 50%) 109 3.71
1000 (aprox. 60%) 131 4.45
800 (aprox. 70%) 153 5.19
1400 (aprox. 50%) 81 2.83
cIron Dry * 1000 (aprox. 60%) 97 3.40
800 (aprox. 70%) 113 3.96
I Synthetics 3.5 kg
+. Cupboard Dry* 800 (aprox. 40%) 48 1.48
600 (aprox. 50%) 60 1.85
*Test program to DIN EN 61121.
**The values may deviate from the values shown here, because of over/undervoltage, type
of fabric, composition of the laundry to be dried, residual moisture in the material and size of
the load.
Optional accessories (order from the after-sales service using the order number)
Washer-dryer stack connection set
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. This connection set must always be used to secure the dryer to the washing
machine. If the worktop of the washing machine is less than 544 mm deep, please consult
the after-sales service or your specialist retailer.
WTZ
11311
10
What to do if ...
If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales
service. We will always find an appropriate solution and will avoid unnecessary visits by
engineers. Trust the expertise of the manufacturer and rest assured that the repair will be
carried out by trained service technicians using original spare parts. The contact details of your
local after-sales service can be found in the enclosed after-sales service directory. When
contacting the after-sales service, please quote the appliance's product number (E no.) and
production number (FD) (see the inside of the door).
Set the programme selector to Off and remove the appliance plug from the socket.
ʠ
The Start/Stop indicator light
does not come on.
Mains plug plugged in?
Programme selected?
Check the socket fuse.
ʠ
The Container empty /Clean
./Ä indicator light comes on.
Empty the condensation container a page 4.
ʠ
The Container empty /Clean
./Ä indicator light is flashing.
Clean the fluff filter
a page 4.
Clean the air cooler if necessary a page 6.
ʠ
Dryer does not start. Has the Start/Stop button been pressed?
Door closed?
Programme set?
ʠ
Programme stops shortly after it
has started.
Ambient temperature greater than 5 °C?
ʠ
Water is leaking out. Make sure the dryer is level.
ʠ
The door opens by itself. Push the door closed until you hear it engage.
ʠ
The required degree of dryness
was not achieved or the drying
time was too long.
Clean the fluff filter a page 4.
Empty the condensation container.
Ambient temperature higher than 35 °C a airing.
Air inlet may be blocked a keep unobstructed.
Was an unsuitable programme selected? a page 7.
Has the dryer been installed with sufficient space on all
sides? Ensure that air can circulate.
Mains failure a Restart the dryer.
Thin layer of limescale on the moisture sensors. Clean the
moisture sensors a page 6.
ʠ
Laundry damp. Use the next drying programme up or use the timer
programme as a supplement a page 7.
Warm laundry feels damper than it really is!
ʠ
The humidity in the room
has increased significantly.
Make sure the room is sufficiently ventilated.
Air inlet blocked? a keep unobstructed.
Ensure that the air cooler is in use.
ʠ
One or more indicator lights is/are
flashing.
Clean the air fluff filter and air cooler if necessary
a page 4/6.
Check the installation conditions
a page 8.
Switch off, allow to cool, switch on again and restart the
programme.
ʠ
Mains failure. Remove laundry from the dryer immediately and spread
out. This allows the heat to dissipate.
a
a
a
a
a
a
a
a
a