Owner's Manual
English • 7Installation Guide • FreeSpace FS2C
PRO.BOSE.COM
Installation
Mounting the Loudspeaker
1. Pass the audio wire through the wire opening.
2. Wire the connector and insert the connector into the loudspeaker. Tighten the conduit fitting if applicable. For wiring information, see
Wiring the Loudspeaker on page5.
3. Insert the loudspeaker through the hole and into the tile bridge or rough-in pan (see page 6) and turn (counterclockwise) the anchor
arm screws one half turn to release the anchor arms. Slowly lower the loudspeaker until the anchor arms engage on the tile bridge or
rough-in pan.
4. Tighten the anchor arm screws to secure the loudspeaker.
WARNING: Over-tightening or over-loosening the screws may result in damage to the anchor arms, the anchor attachment
point, or the ceiling, which could lead to a falling hazard.
q
e
w
r
Attaching the Grille
Note: Before attaching the grille, adjust the loudspeaker tap
settings to the appropriate setting for the installation. See
Loudspeaker Settings on page 5.
After determining the logo alignment appropriate for the
installation, line up the grille with the inside of the loudspeaker
enclosure and push upward until it is secured into place. If
necessary, push the grille tabs inward to properly fit into the
loudspeaker enclosure.
Removing the Grille
Insert a small tool (no larger than 1.5 millimeters in diameter) through the grille perforation at the edge of the grille and pull to disengage
the grille.
CAUTION: Do not use a screwdriver to pry the grille from the enclosure. This could result in damage to the loudspeaker.