Owner's Manual
Table Of Contents
- Owner’s Guide
- Important Safety Instructions
- Contents
- Introduction
- Setting Up the System
- Operation
- F1 Model 812 Control Panel
- F1 Subwoofer Control Panel
- Power On/Off Sequence
- Setting EQ selector switches
- Connecting Sources
- Connection Scenarios
- Full band, mixing console stereo output to L/R F1 Model 812 Loudspeakers
- Full band with mixing console, one F1 Subwoofer and two F1 Model 812 Loudspeakers
- Mixing console stereo output to F1 Subwoofer and left/right F1 Model 812 Loudspeakers
- Full band with mixing console stereo output to two F1 Subwoofers and two F1 Model 812 Loudspeakers
- Stereo input to Left/right F1 Subwoofers and F1 Model 812 Loudspeakers
- Mic to F1 Model 812 Loudspeaker INPUT 1
- Mobile device to single F1 Model 812 Loudspeaker
- Mobile device to F1 Flexible Array Loudspeaker system
- Mobile device to F1 Model 812 Loudspeaker and F1 Subwoofer
- DJ Console to two F1 Subwoofers and two F1 Model 812 Loudspeakers
- Care and Maintenance
- Additional Resources
8 - English
Setting Up the System
Using the F1 Model 812 with the F1 Subwoofer
The built-in loudspeaker stand is stored in the rear of the subwoofer. Setting up the F1 Model 812 Loudspeaker with
the F1 Subwoofer is easy:
1. Remove the built-in speaker stand from the back of the F1 Subwoofer and insert it into the stand slots.
Built-in speaker
stand
Stand slots
2. Lift the F1 Model 812 Loudspeaker and place it on the stand.
-ii
'~
'~.I
(·A
----