Owner's Manual
Table Of Contents
- Owner’s Guide
- Important Safety Instructions
- Contents
- Introduction
- Setting Up the System
- Operation
- F1 Model 812 Control Panel
- F1 Subwoofer Control Panel
- Power On/Off Sequence
- Setting EQ selector switches
- Connecting Sources
- Connection Scenarios
- Full band, mixing console stereo output to L/R F1 Model 812 Loudspeakers
- Full band with mixing console, one F1 Subwoofer and two F1 Model 812 Loudspeakers
- Mixing console stereo output to F1 Subwoofer and left/right F1 Model 812 Loudspeakers
- Full band with mixing console stereo output to two F1 Subwoofers and two F1 Model 812 Loudspeakers
- Stereo input to Left/right F1 Subwoofers and F1 Model 812 Loudspeakers
- Mic to F1 Model 812 Loudspeaker INPUT 1
- Mobile device to single F1 Model 812 Loudspeaker
- Mobile device to F1 Flexible Array Loudspeaker system
- Mobile device to F1 Model 812 Loudspeaker and F1 Subwoofer
- DJ Console to two F1 Subwoofers and two F1 Model 812 Loudspeakers
- Care and Maintenance
- Additional Resources
English - 9
Setting Up the System
3. Plug in your audio cables. Feed the cables from the F1 Model 812 through the channels in the speaker stand to
help keep them organized.
Cable
channel
(both sides)
Using the F1 Model 812 on a Tripod Stand
The bottom of the F1 Model 812 Loudspeaker includes pole cup for mounting the loudspeaker on a tripod speaker
stand. The pole cup fits a standard 35 mm post.
WARNING: Do not use the F1 Model 812 Loudspeaker with a tripod stand that is unstable. The loudspeaker is only
designed for use on a 35 mm pole, and the tripod stand must be capable of supporting a loudspeaker with a minimum
weight of 44.5 lb (20.2 Kg) lbs and an overall size of 26.1" H x 13.1" W x 14.6" D (665 mm H x 334 mm W x 373 mm D)
inches (mm). Using a tripod stand that is not designed to support the size and mass of the F1 Model 812
Loudspeaker may lead to an unstable and hazardous condition that could result in injury.
Pole cup fits a standard
35 mm tripod stand
··
;-1
- I• .