User Manual

24
DISASSEMBLY PROCEDURE CONTINUED
3. Left and Right End Cap Removal
3.1 Remove the six screws securing the left
End Cap. Repeat this step for the Right End
Cap.
4. Top Cap Removal
4.1 Remove the foam tape covering the top
cap screws.
4.2 Remove the four screws from the front
side of the assembly.
4.3 Remove the foam tape covering the
screws holding the top cap to rear side of the
assembly.
4.4 Remove the four screws from the rear
side of the assembly.
4.5 Grab the front middle section of top cover
an pull upward to release the cover.
4.6 Remove the cable from the button board,
then remove the top cap.
5. Button Board Removal
5.1 Remove the four Phillips-head screws
from the button board.
Button Board Removal
continued on next page.
Grab the middle front of the top cover and lift upward to release