User Manual

34
FUNCTIONAL TEST PROCEDURES
SoundTouch™ 30 WiFi Music System
Miscellaneous Tests
1. IR Remote Test
1.1 Confirm power is applied.
1.2 Press each button on the remote control
confirming the display reacts to each button
press.
2. Keypad Button Test
2.1 Confirm power is applied to the
SoundTouch 30.
2.2 Press each button the SoundTouch 30
keypad confirming the display reacts to each
button press.
3. USB Port Functional Test
3.1 Connect the SoundTouch 30 to a com-
puter as shown in the TAP command set up
documented on pages 23 and 24.
3.2 Type the command “local_services on”
and <enter>. Then press CTRL-C on the
keyboard. Then send the command “e” and
<enter>. A command line
mojo login: should
be displayed on the computer.
3.3 Type the command root and <enter>.
This will cause the command line to change
to
root@mojo:root#.
3.4 Connect a USB thumb drive into the USB
port located on the back of the product.
3.5 Type the command “lsusb”.
3.6 Verify the USB memory stick lights up
and the name of the USB memory stick is
visible.
3.7 Send the command “rm /mnt/nv/
local_services” and <enter>.
3.8 Send the command “exit” and <enter>.
This will return to the TAP interface (CLI) and
a TAP command line “->” should be shown.
4. Micro USB Port Functional Test
4.1 Using a micro USB to standard USB
cable, insert a micro USB end of the cable into
the SoundTouch connector labeled SETUP A
(micro USB). Plug the other end of the cable
into a USB port on the computer. Ensure that
cable is properly seated.
4.2 Open your device manger and look under
Network Adapters. You should see the Sound-
Touch 20 as an adapter.
Directions: On your computer, click on Start
and navigate to Run. In the window that
opens, enter “mmc devmgmt.msc”. The
device manager will open. In the device
manager, expand the network adapters, you
should see the SountTouch 30 as an adapter.
5. Ethernet Connector Functional Test
5.1 Insert an Ethernet cable into the Ethernet
connector on the SoundTouch system. Con-
nect the other end of the cable to the router.
5.2 The LED lights on the Ethernet connector
from the SoundTouch should light up yellow
and green after a few seconds indicating that
this connector is functioning.