User's Manual

Operation

English - 21

Routing Input Signals to the Aux Outputs

The Aux function allows you to route signals to two Aux outputs (T4S only) or four Aux outputs (T8S only)

for various signal processing, recording, and sound reinforcement applications. The signal level is adjustable

for each of the available Aux outputs:

Note: To mute the Aux output, press the Level control. Press it again to unmute.

1. Press or rotate the Menu control and select an Aux Send.

2. Rotate the Level control to adjust the signal level of the selected channel.

3. Rotate the Tap control to scroll through the tap menu and highlight the desired tap point.

A. Dry: After Preamp – The completely dry (no processing) signal is routed directly from the preamp

stage.

B. Pre: With EQ & Fx – The signal is routed from the preamp stage with applied processing.

C. Post: After Fader – The signal is routed after the Channel volume control with applied processing.

4. Press the Select control to select the tap point, or press the Cancel control to exit with no change. The

name of the currently selected tap point appears in bold type.

Ch 1

Menu Tap

Aux

Level

50%

Aux 1 Output

Using the Tuner

An independent tuner is available on each input channel. The display indicates the note being played at the

bottom of the screen. As you tune, a pitch indicator appears on the display, showing you whether the note is

sharp or ﬂat. Adjust the pitch of your instrument so the cursor aligns itself with the center of the screen.

Note: For silent tuning, press the Mute button for the applicable channel.

Use the Transpose feature to change the reference pitch up or down by two half steps. Or precisely dial in

your tuning using the reference pitch.

Ch 1

Tuner

Pitch indicator