User's Manual

Setting Up Your Acoustic Wave

II CD Changer

Français Español English

Making the connections

Before you start this setup procedure, disconnect the AC power cord on your

Acoustic Wave

music system II and set it aside. You will need to use it again in

Step 3.

On the back of the CD changer there are two cables that connect to your Acoustic Wave

music system II.

1. Insert the two connectors of the AUX input cable into AUX IN jacks on the back of the

music system (Figure 3). Be sure to match the colors of the connectors and jacks: red to

red, and white to white.

2. Plug the attached CD changer power cord into the AC power jack on the back of the

music system.

3. Plug the small end of the power cord into the power jack on the back of the CD changer.

4. Plug the other end of the power cord into an AC (mains) wall outlet.

After applying power, “PLEASE WAIT” appears on the display for about 30

seconds while the system prepares itself for operation. DO NOT insert any

discs until this message disappears.

Figure 3

Connecting cables and

power cords

Acoustic Wave

music system II

AC power cable

AUX input

cable

CD changer power jack

Acoustic Wave

music

system II power jack

AUX IN jacks