Owner's Manual

5
Setting Up Your Acoustic Wave
®
II CD Changer
English FrançaisEspañol
Selecting a location for your music system and changer
The Acoustic Wave
®
II CD changer is designed to fit under your Acoustic Wave
®
music sys-
tem II. Before you connect the two, however, select a good location for the stacked units.
When choosing the location, remember that the tonal quality of your Acoustic Wave
®
music
system II, as with any high-performance sound system, will vary with room placement.
Feel free to try different locations, but keep the following guidelines in mind:
• The Acoustic Wave
®
music system II is designed to sound best when placed on a shelf,
counter, desk, or table top, 30 to 48 inches (75 to 120 cm) from the floor.
• The CD player in the Acoustic Wave
®
music system II needs an allowance of several inches
for the CD cover on top of the music system to open.
• The Acoustic Wave
®
music system II should be near the center of a wall and 6 inches (15
cm), or less, away from the wall.
• To increase the bass response, move the unit toward any corner of the room; to decrease
bass response, move it away from the corner.
Seating your Acoustic Wave
®
music system II on the CD changer
With the CD changer in your chosen location, carefully set your Acoustic Wave
®
music
system II on top of the CD changer (Figure 2a).
• Make sure the Acoustic Wave
®
music system II fits onto the raised guides on top of the CD
changer.
• Make sure the Acoustic Wave
®
music system II sits flat and the side edges of both units are
aligned.
• Make sure there is a clear optical path in front of the unit to allow the infrared emitters and
receivers to communicate (
Figure 2b).
Figure 2
Seating the Acoustic Wave
®
music system on the CD
changer
(a)
(b)
Raised
guides
IR signal
emitters
IR signal
receivers
TM
TM