Owner's Manual

7
English FrançaisEspañol
Operating Your System
Using the remote control
The remote control included with your Acoustic Wave
®
II CD changer allows you to control
functions of both the CD changer and your Acoustic Wave
®
music system II. Therefore, you
only need this remote to control your system.
Just aim the remote at the system and press the
buttons. The remote normally works within 20 feet of the front panel.
If the remote stops operating or its range seems reduced, it may be time to replace the
battery. For instructions, refer to “Replacing the remote control battery” on page 13.
The information in Figure 4 describes the buttons used for playing CDs and selecting auxiliary
inputs. For controlling other functions of the Acoustic Wave
®
music system II, see the owner’s
guide that came with it.
Notes:
• Press-and-hold operations require holding the button down for at least one second.
• Pressing FM, AM, CD, or AUX automatically turns on the system to the source selected.
• The remote can select an external audio source that is connected to the changer, but cannot
turn the source on or off or change its settings.
Figure 4
Acoustic Wave
®
II CD
changer remote control
Throughout this owner’s guide, you will see button icons to the left of the operating instructions.
These icons refer to buttons located on the remote control.
On/Off
Turns the system on or off (page 8).
Seek/Track
Skips to next/previous CD track
(page 10).
Tune/MP3
Scans forward/backward through a CD
track (page 10).
CD
Selects the CD source in the Acoustic
Wave
®
music system II (page 9).
Presets/Discs
Selects CD changer slots 1-5 (page 10).
Stop
Stops a playing CD (page 10).
Play/Pause
Plays a CD or pauses a playing
CD (page 10).
Play Mode
Selects repeat and random CD play
modes (page 10).
Next Disc
Moves to next CD in the changer (page 10).
CD Changer
Selects the CD changer and turns
it on if it is off (page 9).
AUX 1-2
Selects the AUX 1 or AUX 2 input jack
on the rear panel of the CD changer
(page 12).